Table of Contents
Advertisement
L05 User's Manual
DISPLAY
Cursor right or left to select NO to disable the WELCOME MESSAGE or YES to enable
it. Note: If welcome message is enabled, and both LINE 1 and LINE 2 are blank (or
consist entirely of space characters), no message will appear.
LINE 1/LINE 2
Select message LINE 1 or LINE 2. When you first cursor left or right, the ">" at the end
of the menu line disappears, and a blinking hyphen character indicates message edit
mode. Cursor up or down to select a cha racter at the given position. Cursor left or right
to move the cursor to the desired character position. Note: When you cursor to the left or
right margins of the edit space, the blinking hyphen will disappear and ">" will re-appear
at the very end of the menu line. You can then cursor up or down to the next or previous
line in the MESSAGE sub- menu.
CLEAR
Erase the entire message.
CHANNEL GUIDE
The channel guide feature provides an on-screen summary listing of the RF (tuner)
channels that are currently in the channel ring (see CHANNEL INSTALL -> CHANNEL
RING) and have been assigned labels (see CHANNEL INSTALL -> LABEL).
NO:
Channel guide is not displayed when CH GDE on remote is pressed, and a "NOT
AVAILABLE" message appears.
YES: When CH GDE on remote is pressed, the channel guide is displayed for
approximately 10 seconds, or until a remote control command occurs. All RF (tuner)
channels that are in the channel ring, and have labels, will appear in the channel guide
list.
POWER ON: The channel guide appears automatically at power-on, and remains on-
screen for approximately 10 seconds, or until a remote control command occurs. The
channel guide also appears when CH GDE on remote is pressed.
Note 1: To appear in the channel guide, an RF (tuner) channel must be assigned a label,
and must be saved in the channel ring.
(NO/YES)
(>)
(NO / YES / POWER ON)
20
091105.1833
Advertisement
Table of Contents
