1. Manuals
  2. Brands
  3. Salusfin Manuals
  4. Smoke Alarm
  5. SF 9740
  6. User manual

Salusfin SF 9740 User Manual

Hide thumbs
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual
Smoke Detector | SF 9740
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SF 9740 and is the answer not in the manual?

Questions and answers

Summary of Contents for Salusfin SF 9740

  • Page 1 Smoke Detector | SF 9740 User Manual...
  • Page 2 Introduction Thanks for choosing Salusfin wireless smoke detector for the home security. This sensor is a Z-Wave TM enabled device (interoperable, two-way RF mesh networking technology) and is fully compatible with any Z-Wave TM enabled network. Every main powered Z-Wave TM enabled device acts as a signal repeater and multiple devices result in more possible transmission routes which helps eliminate “RF dead-spots”.
  • Page 3 smoke detector will send an alarm sensor report (type: smoke alarm, state: alarm) to the user’s controller and also the detector will send an alarm sensor report (type: smoke alarm, state: No alarm) while the alarm off. 4. Error Mode: If the smoke detector beep and yellow LED flash three times, it indicates the smoke detector is not working properly.
  • Page 4 Specification: Package Content: Protocol: Z-Wave™ (ZS6101N) ZS 6101 smoke detector Frequency Range: Bracket Holder 868.42MHz (ZS6101EU) 2pcs Plastic Anchor & Screws 908.42MHz (ZS6101US) CR123A Lithium Battery 921.42MHz (ZS6101AU) Installation & Operation manual Operating Range Up to 100 feet line of sight Operating Temp.
  • Page 5 For “Association”: After “Awake” mode, then put the Z-Wave TM Interface Controller into “association”, and following its instruction to associate the ZS6101 with other device. Afterward the ZS6101 will get into “Sleep” mode for power saving. One association group supports 5 nodes. For “Auto Wake-up”...

Table of Contents