Breville BKE700 Instruction Book page 9

Functions
BEFORE FIRST USE
Remove any promotional material attached
to your kettle. It is recommended that before
first use, the kettle is filled to the maximum
level with cold tap water, boiled and water
discarded. Your kettle will only operate when
positioned on the power base with
the 'On/Off' switch in the 'On' position.
The kettle will automatically switch off
once the water has boiled.
OPERATION OF YOUR KETTLE
To fill the kettle, remove it from the power
base and open lid by pressing the lid release
button. Fill with the desired amount of water.
NOTE
Always fill the kettle between the minimum
(2 CUPS) and maximum (7 CUPS) marks on
the water window. Too little water will result
in the kettle switching 'Off' before the water
has boiled. Filling above the maximum mark
(MAX) may result in boiling water splashing
from the kettle.
Ensure the lid is locked firmly into place.
Position the kettle securely onto the power
base. Insert the power plug into a 110/120V
power outlet and switch on.
Press the 'On/Off' switch to the 'On' position
for water to boil.
NOTE
This kettle must only be used with the power
base supplied. Use caution when pouring
water from your kettle, as boiling water will
scald. Do not pour the water too quickly.
8
The kettle will automatically switch 'off' once
the water has boiled. Lift the kettle from the
power base and pour the water. Take care to
hold the kettle level, especially when filled
to the maximum level. To re-boil it may be
necessary to wait for a few seconds to allow
the control to reset.
If further heating of the kettle is not required,
unplug the power cord and empty the water
from the kettle. Replace the kettle onto the
power base and close the lid.
SAFETY BOIL DRY PROTECTION
The kettle is fitted with a safety device, which
protects against overheating should the
appliance be operated with insufficient water.
If this occurs, the kettle will stop heating.
Allow kettle to cool before refilling. Remove
the kettle from the power base and add water.
Return the kettle to the power base. The safety
device will then automatically reset.
For additional safety, your kettle is fitted with
an additional thermal cut out. In the event
of overheating, the kettle will automatically
shut down to prevent further damage. Should
this occur, please contact Breville Consumer
Support.