Drilling Stands/Milling Stands Bf1240 | Bf1242 | Bf1243 | Bf1244; Version; Assembly; Lubrication - WABECO BF1242 Operating Instructions Manual

4.

Drilling stands/Milling stands BF1240 | BF1242 | BF1243 | BF1244

4.1

Version

Solid steel column 500 mm, hexagonal steel bracket
No. 24400 without rotary table
No. 24404 with rotary table Ø 180 mm
Solid steel column 500 mm, hexagonal steel bracket
No. 24401 without rotary table
No. 24408 with rotary table Ø 180 mm
Solid steel column 750 mm, hexagonal steel bracket
No. 24500 without rotary table
No. 24504 with rotary table Ø 180 mm
Solid steel column 1000 mm, hexagonal steel bracket
No. 24454 without rotary table
No. 24457 with rotary table Ø 180 mm
4.2

Assembly

1. Please put the column (7) into the hole of the base plate (1).
2. Tighten the clamping screw (1.1).
3. Insert the extension rail (11) into the hexagonal bore of the housing (12), so that the toothing of the
extension rail (11) and the feed shaft (10) fit together.
4. By means of the clamping screws (11.1) the guide is play-free adjustable.
5. Not the drilling and milling stand is complete and ready to work.
6. Fix the drilling and milling stand to a strong support featuring absolute plainness and use 4 screws M8.
4.3

Lubrication

Prior to every use, some commercially available lubricating oil should be applied to the guide column and to
the rotating points of the feed shaft. The housing and the hexagonal steel bracket of the drilling and milling
stand must be moved up and down in this process.
350 mm
500 mm
500 mm
500 mm
35