Summary of Contents for Mocet DH300
- Page 1 DH300 CAT-iq2.0 DECT Handset Quick Start Guide Copyright © 2014, All Rights Reserved. Ver: R02 D/C: 103-0224...
-
Page 2: Federal Communication Commission Interference Statement
MOCET DH300 CAT-iq2.0 DECT Handset Quick Start Guide Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. - Page 3 MOCET CAT-iq2.0 DECT Handset Quick Start Guide The Handset is designed to work in temperatures from 5 C to 40 10. The Handset must be installed at least 1 meter from radio frequency equipment, such as TVs, radios, hi-fi or video equipment (which radiate electromagnetic fields).
-
Page 4: What's In The Package
MOCET DH300 CAT-iq2.0 DECT Handset Quick Start Guide What’s In the Package? 1. Handset with belt clip x 1 2. Charger x 1 3. Power supply MN-A002-A080 ; 7.5 V , 300mA from MEIC x 1 4. Rechargeable batteries NiMH AAA 750 mAh/1.2 V x 2 5. - Page 5 MOCET CAT-iq2.0 DECT Handset Quick Start Guide For entering asterisks. In idle mode: Press and hold down to switch handset ringer on/off. When entering Asterisk key & names, switch between upper and lower case Switch ringer on/off lettering. Start a new external call when you have already an Enquiry key active call.
-
Page 6: Symbols On Display
MOCET DH300 CAT-iq2.0 DECT Handset Quick Start Guide Symbols on Display The following symbols are displayed on your handset. Part Name Description Reception displayed when the handset is within range of the base station. Flashes red when out of range of Coverage symbol the base station or not registered with the base station. - Page 7 MOCET CAT-iq2.0 DECT Handset Quick Start Guide Inserting the rechargeable batteries Insert the batteries in the battery compartment. Make sure the polarity is correct. Insert the batteries so that the flat end (negative polarity) of the battery is pressing against the spring. The handset will not function if the batteries are incorrectly inserted.
- Page 8 MOCET DH300 CAT-iq2.0 DECT Handset Quick Start Guide Charging the batteries The batteries are not yet charged when you first unpack the telephone. Insert the handset in the charger. The flashing battery symbol on the handset shows the charging status.
-
Page 9: Warranty Information
MOCET CAT-iq2.0 DECT Handset Quick Start Guide Warranty Information Thank you for your choice of product. Remember to record your CAT-iq2.0 DECT handset information below for further support service, if needed. This device has Model number and Serial Number which are located on the back of the base unit.
Need help?
Do you have a question about the DH300 and is the answer not in the manual?
Questions and answers