Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for REVU DYNAMIS
- Page 1 Owner’s Manual Dynamis 7-40w...
- Page 3 Congratulations and welcome to the Revv family! The Dynamis guitar amplifier is our way of taking modern guitar amplification and giving it a new defi- nition! One that brings monstrous tone and control together into one design that meets the needs of...
-
Page 4: Table Of Contents
Revv Owner’s Manual contents Serial Effects Loop Warranty Safety Instructions & Warnings Set up & Power up SEND Level Control FX Loop In/Out FX Loop Hook up Front Panel Layout Tubes & Bias Input Channel One Channel Two Power Tubes Reverb &... -
Page 5: Warranty
Revv Dynamis 7-40w warranty This Revv Amplification Inc. product is warranted against manufacturing defects in material and workmanship for a period of five (5) years from the date of purchase to the original owner. Tubes and fuses however will be warranted for ninety (90) days from date of purchase of the product to the original owner and speakers will be warranted for one [1] year. -
Page 6: Safety Instructions & Warnings
Revv Owner’s Manual safety instructions & warnings Please read, understand and follow all safety instructions in this manual, as well as those on the rear panel of the amplifier. These instructions and warnings must be followed for your safety, and also to ensure that the amplifier will serve you for many years. -
Page 7: Set Up & Power Up
Revv Dynamis 7-40w set up & power up It is very important to place the amplifi- Once all your connections are made, er in a dry location that provides 4-6” of move the power switch to the On po- space between the rear of the amplifier... -
Page 8: Front Panel Layout
Revv Owner’s Manual front panel layout dynamic channel BLUE CHANNEL 1 bright TREBLE BASS VOLUME REVERB GAIN TREBLE NORMAL Input ¼” Instrument cable input. this jack can be used with any guitar should a lower gain tone be desired. Low Input – The low input jack has been designed to allow guitars with hot pick- Normal Input –... -
Page 9: Channel One
Revv Dynamis 7-40w dynamic contour reverb on/off CHANNEL 2 decay GAIN TREBLE BASS VOLUME REVERB STANDBY Channel One Selected by: pushing the designated sets the power for channel one only, and front panel momentary toggle switch can be handy when setting the amount... -
Page 10: Channel Two
Revv Owner’s Manual Channel Two Selected by: pushing the designated is left out, but still remain very tight in front panel momentary toggle switch the bottom end and not too harsh at up, or foot switch button #2 on the foot higher frequencies. -
Page 11: Reverb & Decay Switches
Revv Dynamis 7-40w Reverb & Decay Switches The Dynamis amplifier is equipped with Once you have found your desired decay reverb and the ability to select between setting, simply use the reverb level short, medium or long decay reverb control to adjust the amount of reverb to tanks as well as the level of reverb on the selected channel. -
Page 12: Rear Panel Layout
Revv Owner’s Manual rear panel layout WARNING: Unplug power cord MAINS / FUSE BEFORE removing fuse! 100V / T2A BIAS SOLO LEVEL 120V / T2A 230V / T1A 240V / T1A V1/V3 V2/V4 MAINS T.25A T.25A FUSE V1/V3 V2/V4 FOOT SWITCH WARNING: Replace fuses with same type/rating only! Main Power Connection When plugging the amplifier into the... -
Page 13: Power Tube Fuses
4 and 8 ohms should to a speaker cabinet or speaker load you desire to run the amplifier from a when it is powered up. The Dynamis cabinet and not the provided built in 8 amplifier can be used with cabinets that... -
Page 14: Fx Loop Connections
8 ohm cabinets would be Note: In order to prevent damage to your plugged into a 4 ohm jack, and the other Dynamis Amplifier, it is very important to 8 ohm cabinet would be plugged into verify that the speaker load is correct and the remaining 4 ohm jack. -
Page 15: Solo Level Control
Revv Dynamis 7-40w Solo Level Control The solo level control will provide the troller to turn it on. Now adjust the solo amount of solo boost required when level control on the amplifier to increase using the solo boost option on the foot or decrease the volume level. -
Page 16: Fx Loop Hook Up
First, you need to hook up your effects Next, turn on the amp and turn the FX units to the Dynamis Combo. The send loop send level control up slowly as jack will need to be connected to the you play your guitar. -
Page 17: Preamp Tubes
Revv Dynamis 7-40w Preamp Tubes The Dynamis amplifier uses 12AX7 socket. Preamp tubes do not need to preamp tubes in tube positions V1 V2 be biased and usually have a long life and V4. A 12AT7 preamp tube is used in... -
Page 18: Foot Switch
The 6 button foot switch that is used with the Dynamis is not like most foot switch- es. This unit not only controls the amplifiers functions, it can also be used as a pro- gram bank pedal. -
Page 19: Control Mode
Revv Dynamis 7-40w It is recommended that the 6 button foot via the front panel but then decide to plug controller be connected to the amp with the pedal in afterwards, it will update itself the power off, but should you plug it in... -
Page 20: Preset Mode
The LED will switch, it will not be lost if power is stop flashing verifying that the change removed from the amp. The Dynamis foot has been saved. switch has memory and will retain the Now every time you press that bank but- settings. -
Page 21: Fx Loop & Preset Mode
Revv Dynamis 7-40w FX Loop & Preset Mode In order to save an FX Loop setting to a button until it has switched to your bank in preset mode, the FX Loop button desired condition. The Preset bank LED must be held for 2 seconds. This will... -
Page 22: Specifications
Revv Owner’s Manual specifications • 2 Channels: CH1 - Clean / CH2 - Gain • 3 band EQ per channel channel with 3 “dynamic” levels • REVV Tube arrangement: 4 - 12AX7, • Variable wattage: 7 and 40 watt se- 1- 12AT7, 4 - 6V6GT lector switches per channel • 4, 8, 16 ohm output impedance selec- • Reverb: 3 different Decay options tor switch – independently controllable per • Baltic birch head shell channel, and programmable in foot • Dimensions: 21” × 19” × 12.625”... - Page 24 REVV AMPLIFICATION INC 21105 MONDOR ROAD - BOX 299 ILE DE CHENES MB CANADA R0A 0T0 (204) 391- 8399 www.revvamplification.com © 2016 REVV AMPLIFICATION...
Need help?
Do you have a question about the DYNAMIS and is the answer not in the manual?
Questions and answers