Circuit Adjustments; Adjustment With Commander - Sony KV-DZ29M30 Service Manual

KV-DZ29M30/M61/M91
RM-GA002
5-1. ADJUSTMENTS WITH COMMANDER
Service adjustments to this model can be performed using the supplied remote commander RM-GA002.
a. ENTERING SERVICE MODE
With the unit on standby
t [DISPLAY] t 5 t [VOL $+% ] t [POWER]
This operation sequence puts the unit into service mode.
This screen display is:
item no.
category in decimal
WHBL 000
software
release ID version
CGA20
S_ _ : for SONY
A_ _ : for AIWA
L_ _ : BX1L Full
B_ _ : BX1L Basic
D_ _ : DVD Combo
C_ _ : CX1/CX2
Z_ _ : Sound special
_ _ _01 : Serial no. of the M/P release for each
destination
_ _ _10 ~: use for FY04 BX1
_ _SB : Sub Hercules
b. METHOD OF CANCELLATION FROM SERVICE MODE
Set the standby condition (Press [POWER] button on the commander), then press [POWER] button again, hereupon it becomes
TV mode.
c. METHOD OF WRITE INTO MEMORY
1. Set to Service Mode.
2. Press 1 (UP) and 4 (DOWN), to select the adjustment item.
3. Change item by pressing 3, 6.
4. Press [MUTING] button to indicate WRITE on the screen.
5. Press - button to write into memory.
1, 4
r
3, 6
r
[MUTING]
r
-

CIRCUIT ADJUSTMENTS

service data
item name in decimal
WBP
service data
in binary
3.13M 0000 0000
Select the adjustment item.
Raise/lower the data value.
Writes.
Executes the writing.
SECTION 5
NVM service
NG command
000 x SERVICE
reserved
for factory color system
FF FF NTSC3
For BP1 Board Version; and BT Version;
Category and release ID will be different.
The rest are the same. (Not use for this model)
BP1 Board Version
item no.
category in decimal
SUBP
software
release ID version
CBP00
BT Version
item no.
category in decimal
9090
software
release ID version
BT 0A14/M
– 14 –
field
frequency
50
power on time
(decimal)
00100
item service data
name in decimal
000 IDXH
0.00
item service data
name
000 UOF
channel no./
video input name
S VIDEO 1
000
in decimal
000