Download Print this page

Little Partners LPA1103 User Manual

Children's and pet gate wall protector with light

Advertisement

Quick Links

EZ-FIT CHILDREN'S AND PET GATE WALL PROTECTOR WITH LIGHT
!
KEEP INSTRUCTIONS FOR FUTURE USE
!
READ all instructions BEFORE assembly and
USE of the product.
!
Check installation after assembly and
periodically at least once a month to
ensure unit correctly installed.
!
Adult assembly required.
!
CAUTION: FOLLOW ASSEMBLY
INSTRUCTIONS OF THE PRESSURE GATE
AS EACH GATE MAY ASSEMBLE
DIFFERENTLY.
IMPORTANT INFORMATION REGARDING BATTERIES
!
Keep the batteries out of children's reach.
!
Any battery may leak battery acid if mixed with a different battery type, if inserted incorrectly (put in
backwards) or if all batteries are not replaced or recharged at the same time. Do not mix old and new
batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
!
Any battery may leak battery acid or explode if disposed of in fire or an attempt is made to charge a
battery not intended to be recharged. Never recharge a cell of one type in a recharger made for a cell
of another type.
!
Discard leaky batteries immediately. Leaky batteries can cause skin burns or other personal injury.
When discarding batteries, be sure to dispose of them in the proper manner, according to your state
and local regulations.
!
Always remove batteries if the product is not going to be used for a month or more. Batteries left in the
unit may leak and cause damage.
!
Recommended type batteries—alkaline disposables, 3AAA. NEVER mix battery types. Change
batteries when product ceases to operate satisfactorily.
TROUBLESHOOTING:
If your device is not functioning properly, check for the following problems:
1. No batteries in electronics module.
2. Batteries dead.
3. Batteries in backwards—check "+" and "-".
4.Corrosion on battery terminals. Rotate batteries in place against terminals, or clean with sandpaper or
steel wool if corrosion is severe.
5. Batteries too weak.
If you still have problems, call our toll-free number: 1.800.704.9058 or
Large Panel
Grip Tape
Front View
email: customercare@rbollc.com
PART LIST
Silicone
(x1)
Anti Slip
Material
Back View
USEFUL TIP
While one
person can
assemble this
item, it is
recommended
that two people
work together
for easier
assembly.
Grip Tape
Light
Front View
LPA1 LLC.
customercare@rbollc.com
Model #: LPA1103-X
Date Code: MMYYYY-ZZZ
PPI Label Location
LPA1103
Small Panel
(x1)
Back View
PRN: AIM-LPA1103-LPN [16.09.14]
Silicone
Anti Slip
Material
1

Advertisement

loading

Summary of Contents for Little Partners LPA1103

  • Page 1 Small Panel Silicone Anti Slip Material Grip Tape (x1) Light Back View Front View LPA1 LLC. customercare@rbollc.com Model #: LPA1103-X Silicone Date Code: MMYYYY-ZZZ (x1) Grip Tape Anti Slip Material PPI Label Location Front View Back View PRN: AIM-LPA1103-LPN [16.09.14]...
  • Page 2 BATTERY INSTALLATION UNSCREW OPEN CLOSE Three AAA Batteries required. NOT included. Align batteries as shown on inside of compartment. LIGHT ASSEMBLY INSTRUCTION Your light has an ON/OFF switch. Push in to activate the sensor light. Push in again, to prevent light from coming on when Motion occurs around light.
  • Page 3 REMOVING THE LIGHT Insert a small pointed tool, PUSH such as a paperclip or pencil, into the hole to depress the tab to unlock. UNLOCKED REMOVE LOCATION OF YOUR EZ FIT WALL PROTECTOR WITH LIGHT TIGHTEN GATE Assembly of your EZ Fit protector is easier if you have help. An extra set of hands to hold the unit in place while you tighten the gate is recommended.
  • Page 4 DIFFERENT OPTIONS FOR YOUR EZ FIT PROTECTORS One SET - Top and Top on both sides of One SET - Top and Top on both sides of wall with base boards wall with base boards WALL WALL TWO SETS - Top and Bottom on both side on One SET- Top and Bottom on one side on first step.