Standard Recovery Procedure - Appion G5Twin Operation Manual

Machine Usage
⚠ CAUTION
To reduce the risk of injury or product damage, read this entire operating manual, with
particular emphasis on the Safety and Preparation sections (Page 4-8), prior to operating the G5Twin.

STANDARD RECOVERY PROCEDURE

1. Setup the G5Twin as shown in Diagram 4 (below). Make sure that all connections are tight.
A. Connect the AC/R System Liquid Port to the Manifold high side.
B. Connect the AC/R System Vapor Port to the Manifold low side.
C. Connect the Manifold Center port to the G5Twin input port.
D. Connect the G5Twin output port to the Vapor Port on the Recovery Cylinder.
Diagram 4
Recover into the Vapor Port of the Recovery
Cylinder for faster recovery.
OPTIONAL: To improve tank cooling, start
with the recovery cylinder upside down,
and flip the tank right-side up near the end
of the vapor recovery.
2. Close both valves on the Manifold Gauge Set.
3. Open both valves on the G5Twin, open the Valve Core Removal Tool ball valves at the system (if equipped),
and open the Recovery Cylinder Vapor Port.
Make sure to completely open the Recovery Cylinder valve to prevent "output restrictions" (See Tip #1).
4. Turn on the G5Twin. The compressor and fan should start.
5. Slowly open the Manifold High Side (liquid) valve.
Removing liquid first will keep recovery time to a minimum, and improve cooling properties of the recovery
cylinder. NOTE: Overheating or slow recovery speeds may be caused by "input restrictions" (See Tip #2).
6. When all the liquid has been removed, completely open the Manifold Low Side (vapor) valve. Both sides
should now be fully open to maximize vapor flow.
7. Continue to run the G5Twin until the EPA-required vacuum is achieved.
8. Close both valves on the Manifold Gauge set.
9. Turn off the G5Twin, then close the output valve on the G5Twin.
10. Close the G5Twin input valve, close the valves on the Recovery Cylinder, and disconnect the hoses.
B
C
A
9
D
G5TWIN OPERATION MANUAL
© 2016 APPION INC. - ALL RIGHTS RESERVED