RESULT FROM SUCH USE • that the obligations of Whale Spa are limited to those set forth herein • this warranty is limited to the original owner/end-user and is non- transferable • Whale Spa shall not be liable for any other obligations or liabilities, including, but not limited to: obligations or liabilities arising out of breach of contract or warranty, negligence, or other tort or any theory of strict liability with respect to the Pedicure Spa or parts or components thereof or any acts or omissions of Whale Spa.
SAFETY & PRECAUTION The Whale Spa pedicure chairs (herein referred to as pedicure spa) are innovative pedicure spas that have been designed to serve you dependably for many years. Please take time to thoroughly read this entire manual before installation and use. If you The Whale Spa pedicure chairs (herein referred to as pedicure spa) are innovative pedicure spas that have been have any problems or have questions regarding your pedicure spa, please contact Whale Spa’s Technical Support Department at...
SAFETY & PRECAUTION Important Installation and Utility Information COMPLIANCE WITH LOCAL CODES OR INSPECTIONS IS THE RESPONSIBILITY OF THE PURCHASER AND/OR INSTALLER Electrical Service: 110V: A 110V, 60 Hz, 15 Amp GFCI protected grounded circuit must be used to supply power to the pedicure spa.
PIPELESS JET CLEANING Pure-Flo Pipeless Spa Cleaning and Disinfecting Procedure Always check with your state board for required cleaning and disinfecting procedures. It is extremely important to clean and disinfect your pedicure spa after each pedicure, after the last pedicure of the day, and once a week for overnight cleaning. Regular cleaning will help keep your pedicure spa in good working condition.
PEDICURE COMPONENTS PEDICURE COMPONENTS 1. Hot & Cold Water Control 1. Hot & Cold Water Control 2. Glass Bowl 2. Glass Bowl 3. Wooden Armrest 3. Wooden Armrest 4. Flip-out Tray with Cup Holder 4. Flip-out Tray with Cup Holder 5.
JET REMOVAL JET REMOVAL Remove Magnetic Jet from jet base Remove Jet from jet base Jet Unit To remove the jet unit from tub/bowl. Gently pull out the jet unit from jet base Jet base secured on bowl wall To install the jet unit. Assemble all jet unit components in order as before removal, snap the jet unit onto jet base located on tub/bowl To install the jet unit.