Page 2
Other Equipment from Seago Air Force Hover Mowers: Air Force Hover Mowers come in two models, the full size F-19 and the smaller, 2-stroke F-15. Atom Edgers: The Atom Cart Path Edger is fastest walk-behind edger in the world. Shaft drive and cross over blades for unmatched speed and safety.
Table of Contents Contents Engine Care Running the Engine Specifications Stopping the Engine Introduction Machine Maintenance 17-19 Description of Intended Use 5 Cleaning the Air Cleaner Foreseeable Misuse Servicing the Spark Plug Warranty Keeping the Engine Clean Deck Housing Nuts and Bolts Safety Symbols Fuel Maintenance Safety Precautions...
Introduction Thank you for purchasing the Air Force Hover Mower. The following pages are to give you information about maintenance, operation, safety and specifications instructions regarding your new mower. We strongly recommend reading the manual before your first use. All references to the left and right side of the machine are as viewed from behind the mower in the operator’s position.
Warranty LIMITED WARRANTY The manufacturer warrants to the original purchaser that this unit shall be free from defect in material and workmanship under normal use and service for a period of one year from the date of purchase. The manufacturer of the engine furnishes their own warranty and services through their authorized network.
Safety Symbols Manual: Read the instruction manual before using machine. Use the Manual: Refer to the manual when making any adjustments or repairs to the machine. Spark Plug: Disconnect the spark plug when doing any work on the machine . Hot Surface: Be aware of the hot surfaces of your machine during and after use.
Safety Precautions Your machine is perfectly safe if used correctly. Failure to observe the following precautions may result in serious injury. Residual Risks Exhaust contains poisonous carbon monoxide. Do not run the engine without adequate ventilation, and never run the engine indoors. The engine and exhaust become hot during use.
Page 9
Safety Precautions Evaluate the terrain to determine what accessories and attachments are needed to properly and safely perform the job. Only use accessories and attachments approved by Air Force. Inspect the area where the equipment is to be used and remove all objects such as rocks, toys, and wire which can be thrown by the machine.
Page 10
Safety Precautions Avoid operating the machine in wet grass. Be sure of your footing while using this product, especially when backing up. Reduced footing could cause slipping. Walk, never run when operating the Air Force Hover Mower. Operate across the face of slopes, never up and down. Slow down and use extra care when making turns or changing direction on slopes.
Safety Precautions Transport To transport by hand, ensure footstop is securely in place, lift machine by the upper bar of the lower handle and walk the machine. If transporting over lawn, user may engage the engine and push the machine to the destination. If transporting in a utility vehicle, ensure the engine is off and do not start the engine until it is back on the lawn.
Machine Assembly Arrival Checklist Remove the machine from its packaging and make sure you’ve received all of the following parts to ensure your mower is correctly assembled: (5) Throttle Securing Bolt (6) Brake Securing Bolt (8) Handle Securing Kit (10) Footstop Securing Kit (11) Deck/Handle Kit (**) Cable Ties (not shown) [If any pieces are missing, contact your dealer.]...
Before Starting the Machine Prevent Engine Damage To prevent damage to the engine, the machine is shipped without any fluids. The engine must be filled with the correct grade of oil and fuel mix before starting the engine. Fuel Mixing Instructions When operating the Air Force Hover Mower, always use a ration of 25:1 to ensure the highest quality performance.
Starting the Machine Ensure that the Brake Handle moves freely and returns to its resting position when released. Starting the Machine Step One: Push the mower throttle control lever into the open position. Pump the primer bulb behind the fuel tank to release fuel. Close the engine choke lever.
Operating the Machine Cutting Flat Landscapes Begin at the edge of the lawn and mow in a straight line back and forth as you would with a regular walk behind machine. Cutting Slopes and Banks Begin at the top and swing the machine from side to side while carefully and slowly moving down the slope.
Operating the Machine Prevent An Accident Inspect the cutting area before using the mower. Any objects other than grass and leaves should be removed to prevent them from becoming projectiles. Inspect for hidden obstructions, which would cause health and safety risks when coming in contact with the cutting system.
Machine Maintenance To prevent accidents, disconnect the spark plug whenever you are performing any maintenance procedures on the machine. Cleaning the Air Cleaner Remove the air cleaner cover (1) by releasing the catch behind the fuel tank (2) and tilting away from the engine body until it’s released. Remove the air cleaner (3) and bath the foam in fuel and oil or soap and water.
Machine Maintenance Nuts and Bolts Check all securing nuts and bolts regularly to ensure they remain tight. Replace missing or damaged items immediately. Fuel Maintenance Before each use, check the fuel level and ensure that a correct level is maintained. Refer to the “Before Starting the Machine” section for instructions.
Machine Maintenance To replace the cutting system: (1) Drain the fuel by running the engine dry (engine will stop). (2) Remove the spark plug lead and allow the engine to cool. (3) Turn the machine on its left-hand side (carburetor up). If you only need to replace the blades or the blade securing kit, you would not need to remove the cutting disc from the machine.
Maintenance Schedule Service Schedule Maintenance (1) Check the fuel level and look for leaks (2) Check blade system and tighten any loose bolts Before Each Use (3) Check air filter – ensure it is dry (4) Remove debris from the cutting system, impeller, and air intake area of engine After the First 5 Hours (1) Change the engine fuel (first fuel change)
Page 27
Seago’s Mission Statement Seago will serve the golf, sports turf, landscape and consumer markets with the goal to provide the finest specialized turf care equipment and customer service to all customers and potential customers, dealers and end users. The equipment we manufacture will be made from top quality materials and assembled in a correct and precise manner.
Machine Code: Serial Number: WARRANTY REGISTRATION THIS CARD MUST BE COMPLETED AND RETURNED TO REGISTER YOUR MACHINE Course/Business Name: Address: Phone: Contact Person: Purchase Date: Email: Dealer Name: Dealer Location: Sales Representative: DATA PROTECTION: By submitting this form to Seago International, you are authorizing Seago to hold your information for future warranty and future sales/marketing promotional.
Need help?
Do you have a question about the F-15 and is the answer not in the manual?
Questions and answers