Hand Held Products IMAGETEAM 4200 Quick Start Manual page 9

Connecting the Imager for RS-232 Serial Port (External
Power)
1. Turn off power to the terminal/computer.
2. Connect the appropriate interface cable to the imager.
2
3
4
3. Plug the serial connector into the serial port on your computer.
4. Connect the external power supply to the cable.
5. Power up the computer and imager.
RS-232 Serial Port
Scanning the RS-232 interface bar code, programs the imager for an RS-232
interface at 38,400 baud, parity–none, 8 data bits, 1 stop bit, and adds a suffix of
a CR LF.
RS-232 Interface
IMAGETEAM™ 4200 Quick Start Guide 5