Table of Contents
Advertisement
installation
2.3
OPERATOR CONTROLS
The operator has access to two controls and two telecommunication
connectors.
Figure 2-3 depicts the WY-50 rear panel.
® .:::::: ::: •• : ••
@
Modem
Figure 2·3.
REAR PANEL
2.3.1
POWER
CORD
The power cord should be inserted into the connector on the
rear panel and then plugged into the AC power source.
The
AC plug is keyed and cannot be inserted improperly.
2.3.2
Compare the voltage specified on the
configuration label (on back of CRT
enclosure) to the AC power source to
prevent da.aging the terminal.
KEYBOARD
The keyboard should be plugged into the keyboard connector
on the rear panel.
This plug is also keyed and fits only
one way.
Avoid plugging the keyboard in or out with the
power ON.
2.3.3
COMMUNICATIONS CABLING
Connect the communications cable from the host computer or
modem to the communications connector labeled MODEM.
This
port is setup to communicate at 9600 baud, no parity, with
one stop bit and eight data bits.
The operator can change
these parameters by going into the setup (see 2.4).
2-3
Advertisement
Table of Contents
