DISASSEMBLY INSTRUCTIONS 1. Using the unlock key that came with the unit or a similar tool, unlock the Mounting Box and remove toward the rear of the unit. 2. Remove two screws (A) located on the rear of the top cabinet then remove the Top Cabinet. 3.
ALIGNMENT PROCEDURES FM ADJUSTMENT Equipment Required AM IF/RF signal generator Solid-state voltmeter (SSVM) Regulated DC power supply 2-CH voltmeter Distortion meter FM Alignment Using FM Signal Generator Note: Press the radio power switch to on the radio. Signal generator output must be kept as low as possible to avoid overload and clipping.
EXPLODED VIEW PARTS LIST PANEL Ref. No. Description RS Part No. Mfr’s Part No. Lens; (S. OPC0000) DVD W/O RDS 53-D2144-317 T. Panel (S. OPC1202) “F” W/RDS 51-D2121-87B Panel Bottom (F) PC 51-D2123-00 Open Knob (S. OP1202) 52-D2124-80 Reset Spring 36-C8020-00 VOL Knob (S.
EXPLODED VIEW PARTS LIST CABINET Ref. No. Description RS Part No. Mfr’s Part No. Panel Ring (S. OPC1202) 51-16227-80D Base 51-E2124-00 61-D2108-00 U Bracket (DVD/Wire) DVD MECH. Slot Type (HPD-60) 94-02780-00 Heat Sink (For Wire) 61-E2006-00 Top Cabinet 61-B0105-01 Bottom Cabinet (For Wire) 61-B0114-01 Main Fiber 35-B0101-00...
SPECIFICATIONS T. H. D............................. Less than 0.35% Signal to Noise Radio ........................More than 60 dB Channel Separation .........................More than 60 dB Frequency Response .......................... 20Hz - 20kHz Stereo Separating (FM) ........................30 dB (at 1kHz) Signal to Noise Ratio (FM) ......................Better than 50 dB Output Power...............................