CO/Tech AR0027 Instruction Manual

ALBIN LED Wall Light
Art.no 36-4855
Please read the entire instruction manual before using the product and save it for future reference.
We reserve the right for any errors in text or images and any necessary changes made to technical data.
If you have any questions regarding technical problems please contact our Customer Services.
1. Location
Consider the following
advice:
• The most suitable
height to mount
the light at is
1.8–2.5 m above
the ground.
• Ideally, the light
should be horizontal.
2. Installation
1. Wall screws
2. Wall bracket
3. Spring washer
4. Plain washer
5. M6 bolt
6. Cable gland
7. Rubber
grommet
8. Lamp housing
9. Terminal block
10. Cable strain
relief with bolts
11. Junction
box cover
(with bolts)
Important: Read the entire instruction manual before
installation. The installation should be carried out by
a qualified electrician and conform to current regulations.
Warning: Make sure that the power is turned off and that
the fuse is removed before beginning any installation,
change of light bulb or service.
GREAT BRITAIN • CUSTOMER SERVICE contact number: 08545 300 9799
e-mail: customerservice@clasohlson.co.uk internet: www.clasohlson.com/uk
Model AR0027-black
1
2
3
4
5
6 7 8 9
10
11
1. Undo the M6 bolts and take off the wall bracket (2).
Don't mix the washers up.
2. Mark out the position of the mounting holes on
the wall using the wall bracket as a template.
Drill holes for the mounting screws (1). Use suitable
screws and wall plugs if necessary. The floodlight
must be fixed securely. Before starting to drill, check
that there are no hidden electrical cables or water
pipes in the wall.
3. Remove the bolts holding the junction box cover
on, remove the cable gland and the strain relief and
thread the power cable (3G, 0.75) into the junction
box through the cable gland and rubber grommet.
4. Connect the three wires: L - Live (brown), N - Neutral
(blue) and - Electrical earth (green/yellow) to
the terminal block as marked in the junction box.
5. Push the terminal block into the junction box and
clamp the cable in place using the strain relief.
Then refit the junction box cover.
6. Bolt the lamp housing to the wall bracket.
7. Tilt the lamp housing to the desired angle and tighten
the bolts (1).
8. Replace the fuse.
3. Disposal
This product should be disposed of in accordance with
local regulations. If you are unsure how to proceed,
contact your local authority.

4. Technical data

Ideal for use with motion detectors.
220–240 V AC, 50 Hz
Mains supply
Power 20 W
Light source 14 × 1 W LED (non-replaceable)
Bright LEDs (6,500 K), 770 lm
210 × 130 mm
Aperture
Protection class IP44 (approved for outdoor use)
Safety class Class 1 (this light fitting must
be earthed)