Philips 24MC4306/37 Service Manual page 28

15. Convergence Adjustment
Purpose: To obtain proper convergence of red, green
and blue beams.
Symptom of Misadjustment: If Convergence
Adjustment is incorrect, the edge of white letters may
have color edges.
Test Point Adj. Point
C.P. Magnet (RB)
--- C.P. Magnet (RB-G)
Deflection Yoke
Tape M. EQ.
--- Pattern Generator
CRT
COIL
DY WEDGE
DEFLECTION YOKE
C.P. MAGNET (RB)
R
G
B
C.B. MAGNET (RB-G)
RB
G
1. Set the unit to the AUX mode which is located
before CH2 then input a dot or crosshatch pattern.
2. Loosen the Ring Lock and align red with blue dots
or crosshatch at the center of the screen by
rotating (RB) C.P. Magnets. (See Fig. 7.)
3. Align red / blue with green dots at the center of the
screen by rotating (RB-G) C.P. Magnet.
(See Fig. 8.)
4. Fix the C.P. Magnets by tightening the Ring Lock.
5. Remove the DY Wedges and slightly tilt the
Deflection Yoke horizontally and vertically to
obtain the best overall convergence.
Mode Input
Dot Pattern
---
Crosshatch
Spec.
See below
Figure
PURITY RB RB-G
SCREW
RING LOCK
SCREW
C.P. MAGNET CLAMPER
C.P. MAGNET
COIL CLAMPER
Fig. 6
R
G
B
Fig. 7
RB
Fig. 8
6. Fix the Deflection Yoke by carefully inserting the
DY Wedges between CRT and Deflection Yoke.
or
G
1-7-7 T2221EA