Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for SLE SMART MIRROR
- Page 2 SMART MIRROR INSTALLATION MANUAL AND USER GUIDE INSTALLATION MOVEMENT BRIGHTNESS CORRELATED SCHEDULER SENSOR COLOUR TEMPERATURE Lighting solution for dressing rooms...
- Page 3 INSTALLATION 700 mm 1. Drill holes according to the picture above. 2. Insert wall plugs in the holes and screw the wall brackets into the anchor tightly. NOTE: Before you hang the mirror, make sure the sensor on the bottom side is hidden behind the mirror, otherwise it could get damaged.
- Page 4 MOVEMENT SENSOR Sensor position: HIDDEN Sensor position: POSITION 1 When buying the Smart Mirror, the Movement sensors in the dressing rooms movement sensor on the bottom side is which are not closed from all sides could hidden behind the mirror.
- Page 5 BRIGHTNESS CORRELATED COLOUR TEMPERATURE (CCT) 4 seconds 4 seconds Brightness Correlated Colour Temperature Setting Setting (CCT) Brightness is set to 100 % by the The brightness level can be adjusted from You can set up CCT. manufacturer. 10 to 100 %. CCT is set by the manufacturer as follows: Instructions: Instructions:...
- Page 6 SCHEDULER RESET Automatic switch-off RESET 4 seconds 4 seconds (after 1 minute) Automatic switch-off Settings Reset If the sensor does not detect any movement The scheduler of automatic switch-off can It is possible to reset the mirror to the for more than 1 minute, the lighting of be set in the range from 1 to 7 minutes or factory settings.
- Page 7 Dojč 419 906 02 Dojč Slovakia +421 34 694 0847 office@sleprojects.com www.sleprojects.com...
Need help?
Do you have a question about the SMART MIRROR and is the answer not in the manual?
Questions and answers