Advertisement
Advertisement
Table of Contents
Summary of Contents for J&J Sanitary Ware SPA-565
- Page 1 HOT TUB Model SPA-565 OPERATING INSTRUCTION...
- Page 2 I 、 Illustration to buttons Fig.1： Control Panel “ ” “ ” Frequency up- searching / Minute On-off/Setting confirm “ ” “ ” Frequency down- searching/ Hour Radio or DVD/TV Switch/ On-off HOUR “ ” “ ” Volume up/ Set switch Blower On-off/℉...
-
Page 3: Function Summary
II、 Function Summary 1 、 Max. with 6 KW heating system, set pre-heating, set and display temperature With 3 surfing pumps,1 circulation pump, 1 view pump, and 1 blower. 、 3、Ozone, Spa lights. 4、CD audio-input / Display of radio frequency and preserve 10 channels 5、Volume display and 87 frequency adjustment 6、Circulation cleaning and time set of circulation cleaning 7、24 hours display and time set... - Page 4 “ ” In the status of time setting It will add 1 minute when pressing each time and the minutes “ ” could be added continually when pressing the without stopping. The minute adjustment range is 0~59 The system will quit the time-setting status automatically after 6 seconds without pressing any buttons 4、Set pre- circulation-cleaning：...
- Page 5 1） circulation 2） Set start of circulation 3） Set lasting time for circulation 4） Finished 3) 、 Press“ ” to set the circulation times; it will show the minimum(5 minutes) on the LCD and this time will not flash. It will add 5 minutes by pressing “ ”...
-
Page 6: Preset Temperature
Only one pre-heating setting is allowed each day if required.The LCD can show clearly in the following figures whether pre-heating settings are set or not See following Fig.7-8： Fig.7： Pre-heat On 图 8： Pre-heat Off Pre-heating is set when the spa is in the “Power off” status and the LCD display shows “---” 1 ）... - Page 7 1） 、 Press “” and enter Pre-heating setting mode, and the LCD flashes of “ON” , the “PREHEAT” icon will flash , and then the circulation works on. Press “ ”again to turn off pre-heating. The LCD will show “OFF” without flashing. 2）...
-
Page 8: Temperature Setting
ON/OFF Or Pressing the “ ”or“ ”key can stop preheating. ***Notice*** When setting temperature lower than equal with water temperature ， Even the Preheating is on, but the circulation PUMP and HEATER are not working。 When the HEATER is “I” type frame，The power of circulation PUMP must reach 750W 。... - Page 9 Fig.11 ： Radio frequency is 105.2 MHZ，Save the present frequency to channel 3 (Save channel) or Exchange the frequency form channel 3 to the present (Searching channel) I、 “ ” is the ON/OFF key for radio and CD。 and it is only available in the status of power on. The first pressing “...
- Page 10 2） With the setting above, the circulation pump will work automatically. 3）、 If the temperature is set at 35℃, when the water temperature reaches or exceeds 36℃, the heater will be turned off automatically and the circulation pump will stop after 5 seconds. When the water temperature reaches or is lower than 34℃, the heater will start up again.
- Page 11 Details concerning cleaning and other maintenance f. Maintenance of water purity, especially PH values and chlorine concentrations. Cleaning and disinfection Use and installation of a cover. i. Disposal of water j. Precautions to avoid damage due to water freezing Precautions to avoid damage when the appliance is left empty for extended period. 2.2 Sub-clause 7 The installation instruction shall state the substance of the following: - Earthed appliances must be permanently connected to fixed wiring;...
- Page 12 No power supply 1. The electric leakage switch was 1. Check and eliminate the malfunction, breaked off restart the spa 2. The Fuse be break off 2. Please change fuse No display on control 1. The plug which connected with the 1.