Table of Contents
Advertisement
Press ENT
INIT. ALL
Erase all stored data from the Flash-Rom of the selected dome camera (FACTORY DEFAULT).
You will be asked to enter Yes or No. If you intend to erase all data then press the
, otherwise press
HOME
data (Titles, Presets, and Tours).
2.11.2. DOME RESET
The main power of the camera will be turned off and then ON again.
CYBERSCAN PRE PACK
HOME
SYSINFO
DISPLAY
DOME SETUP
ALARMS
CAMERA
INITDATA
CONFIG
DOME RESET
LANGUAGE
GENERAL
EXIT
2.11.3. GENERAL
---- CYBER SCAN DOME ----
HOME
SYSINFO
DISPLAY
DOME SETUP
ALARMS
CAMERA
INITDATA
DOME RESET
CONFIG
LANGUAGE
GENERAL
EXIT
2008.
GLOBAL FUNCTION : ON/OFF (Factory Mode : OFF)
This feature is used to enable or disable the GLOBAL Key function.
For detail information, refer to Page 29.
② PAN OFFSET : Pan offset angle. In the screen (original pan angle + offset angle) is
displayed.
③ PRESET SPD(DEG/SEC) : Maximum master preset speed.
360/430/500 degree/sec selectable.
④ ARPC : ON/OFF (Factory Mode : ON)
Automatic recognition
C
INITIALIZATION DATA...
to exit without erasing. The erased data includes all stored
CLR/ESC
Press ENT or Push the
joystick to the right
Press ENT or Push the
joystick to the right
of positioning com
UDP Co., Ltd.
On Screen Menu Operation Manual
RESET:[HOME][ENT][F.NEAR]KEY
EXIT :[CLR/ESC][F.FAR]KEY
◄◄GENERAL CONFIG SETUP►►
--------------------------------------------------
GLOBAL FUNCTION
PAN OFFSET
PRESET SPD(DEG/SEC)
ARPC
UNIVERSAL D.TIME
--------------------------------------------------
SAVE
pensation. The dome recognize pan/tilt angle
or
ENT
: OFF
: 000.00
: 360
: ON
: OFF
EXIT
26
Advertisement
Table of Contents
