2.6 Unit conversion 2.7 Low battery voltage indicating 2.8 Backlight selection (LCD display) 2.9 Auto shut-off 2.10 Key beep sound selecting 2.11 Simple rectifying 2.12 RS-232C output (option) 3. Construction Cursor and Description: Appears when the loaded weight is within ±0.25e Appears when AC power on ▪■■■...
5. Operation and Setting 5.1 Power-on a. Adjust bearing support to make sure the scale is level. b. While using AC power, insert power supply plug (or connect it with the power adaptor). At the same time, if need to turn on DC power or charge the storage battery, switch on the storage battery switch at "I"...
be switched off and the relevant cursor will disappear. Note: No matter whether its backlight function has been switched on or not, the backlight will automatically switch on about 1 second once powered on. 5.7 Auto Shut-off If this function enabled, the scale will automatically shut off in 4 minutes after operation stop, at this time the indicating cursor "Auto Off"...
Page 6
7. Use Guide 7.1 The scale should be levelly placed. Though the scale has good protection, it is suggested to use in clean and stable condition. 7.2 While weighing, place the load in the center of the platform as far as possible. 7.3 Never use high corrosive solvent to clean it.