LG 52SZ8R Service Manual page 24

<Fig 21. CCA Automatic Adjustment Set-up>
3) Sequence of Adjustment
(1) Auto adjustment program is practiced ( ccws.exe)
(2) Measure Model is chosen in Work->Select_Model(*cmf
pile)
(3) Check 'Cool Inspection', Warm Inspection', Medium
Inspection' box of left column in the main screen come to
be checked.
*If it was not checked, Inspection is not practiced after doing
measure.
<Fig 22.CCA Automatic adjustment program main screen >
(4) Click Auto Measure.
->There is progress situation in the right Auto CCA Process.
(Start measure automatically to R->G->B->W order,
practicing to inspection about White, OK, NG are judged in
the right subpart and then being marked.)
(5) Adjustment finishing in case OK.
(6) In case NG, Auto Measure is again practiced in 1~2 times.
In cats NG, adjustment NG is managed to repractice of the 3
times.
(7) Set CA-210 Sync type : Set Sync to univ.
4) 44/52SZ8R-ZA CCA Automatic Adjustment Target Value.
44/52SZ8R-ZA
Coordinate
Cool 275
Warm 313
Medium 287
5) Program Edit.
(1) Model Edit : Interval time and Target White coordinate
that are between command words per Mode, being possible
to correct a common difference.<Fig 17>
<Fig 23. CCA Automatic Adjustment program main Screen>
(2) Port Edit : CA-210 and RS-232C Connection setting about
SET < Fig 23>.
<Fig 24. CCA Automatic Adjustment program main Screen>
*** To be impossible auto adjustment manual adjustment***
(1) Entry become to IN-START-> Optics Check order using
the adjustment remote controller.
(2) Color coordinates (x, y, L) of White is measured choosing
Full Color.
(3) After Green, Red, Blue using CH-(
coordinates is measured.
(4) Entry becomes to Manual CCA in the ADJ adjustment
mode of adjustment remote controller.
(5) After fitting Color Temp to Normal, measured color
coordinates value of R, G, B, W are input.
- 24 -
X Y
Tolerance
Coordinate
277
!6
320
!6
289
!6
E
Color
Temperature
11600K
6600K
9300K
) key, each color