Table of Contents
Advertisement
Press the UPC key to accept the terms and
conditions. A short description of all the
features in the Digital Cable Receiver with
a UPC subscription will be displayed, and a
test will start to check that setup is done
correctly.
Search failure
In case of channel search failure, before starting
a new search, check the following points:
•
RF cable condition and connection to your
Digital Cable Receiver as described in
chapter Connect
•
Signal quality
•
Correct activation code is entered
Note
If the same failure message appears after a while,
refer to chapter Frequently asked questions.
If the problem remains, contact your dealer.
71
5
Using your Digital
Cable Receiver
Once you have connected the Digital Cable
Receiver, use the remote control to operate
the basic, frequently-used functions, such as
switching on and off and changing channels.
You will also become familiar with the handy
Programme Information Bar. This is used to
display information on the programme you are
watching, search for another programme, or
change channels.
5.1
Switching the Digital Cable
Receiver on and off
•
Press the
UPC key on the remote control
to switch on the Digital Cable Receiver.
•
Press
to switch off the Digital Cable
Receiver.
Tip
You can also switch on the Digital Cable
Receiver by pressing the CH+/- keys, and set
it to standby by pressing the
front of the Digital Cable Receiver.
5.2
Changing channels
There are various ways of using the remote
control to quickly change channels.
Zapping
Press CH+/- to quickly switch between adjacent
channels.
•
Press
CH+ once to change from channel 1
to channel 2.
•
Press
CH- once to change from channel 2
to channel 1.
Tip
You can also use the
the front panel of the Digital Cable Receiver to
quickly switch between adjacent channels.
Using your Digital Cable Receiver
button on the
,
,
and
buttons on
Advertisement
Table of Contents
