Run A Program Cycle Manually; Run A 3 Minute Test (Syringe); Advanced Features - Nelson ez pro Instruction Manual

ADVANCED FEATURES

The EZ Pro™ incorporates Nelson's ManualAdvance™ feature in the MANUAL procedure.
ManualAdvance™ allows you to cease the currently running zone and immediately advance
to any new zone you select. With the MANUAL procedure running a zone, press SELECT
to advance to a new zone. The last entered run time will be displayed. Press ADJUST
enter a new run time for the new zone (the controller will delay 5 seconds before starting the
new zone).

Run a Program Cycle Manually

Turn the large dial to the CYCLE position. The current program letter will flash. To change to a
different program, turn the PROGRAM dial to the desired program (A, B, or C). The controller
will delay 10 seconds before starting the selected program. After running, the controller resets
to the AUTO procedure.
NOTE: CYCLE runs your current program immediately. Changes cannot be made to the
program in the CYCLE procedure.

Run a 3 Minute Test (Syringe)

Turn the large dial to the 3 MINUTE TEST position. A B C will flash on the LCD (they cannot
be changed). This is to let you know the controller will review all three programs and run a 3
minute test on only those zones that have been programmed. We call this SmartSyringe™.
This feature allows the controller to skip zones that have not been programmed. These may be
zones that are not hooked-up, hence, saving your pump (if equipped).
to
20