Rear Panel - Philips RCP7005TP2L Owner's Manual

AERIAL
Connect the aerial to this terminal.
AC Power Cord
Plug into the power source.
AERIAL
RF.OUT
RF. OUT
Passes the signal from the AERIAL to your TV/monitor
Important Note
About Ferrite Core
Be sure to attach the ferrite core to the power cord (for
connecting to this unit).
This ferrite core can reduce noises.
1
Push the stopper [a] of the ferrite core to open.
2
Wind the power cord twice on ferrite core.
3
Close the ferrite core until it clicks.
Caution
Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
COMPONENT/PROGRESSIVE SCAN VIDEO OUT (Y Pb Pr)
Connect to a TV with Y Pb Pr inputs.
AUDIO OUT (Left/Right)
Connect to an amplifier, receiver or stereo system.
COAXIAL (Digital audio out jack)
Connect to digital (coaxial) audio equipment.
VIDEO OUTPUT Switch
Select either COMPONENT VIDEO OUT or RGB signal of EURO AV1 AUDIO/
VIDEO terminal depending on how you connect the Recorder to the TV.
S-VIDEO OUT
Connect to a S-Video Input on TV.
EURO AV 2 DECODER
Connect the audio/video output of an external source
(Pay-TV decoder, Set Top Box, VCR, etc.).
EURO AV 1 AUDIO/VIDEO
Connect to a TV with SCART jack.
1
2

Rear Panel

[a]
15