Advertisement
HOW ' I-0 OYERA' I-E
(I )Remove the cap cover from the top of the lens mount.
(2) If CS mount lens is used , also remove the C mount ring.
(3) Screw the lens into the lens mount Rep: I.
(4) Connect the video output Rep:4 to the monitor or other video
device through a 75 Ohms type coaxial cable.
(5) Connect the power Rep:7 source. AC with the power cord.
(6) Once the picture appears on the monitor, adjust the focus and
iris of the lens to obtain the best picture.
(7) If the subject is not in correct focus when adjusting focus of
the lens, do back focus, adjust as follows:
1: Set the focus ring of the lens to indefinite position.
II- Take picture of subject at a distance more than 20 m away
III- Loosen the mount lens fixing screw Rep:2 (use L wrench).
IV- Turn the lens and the mount lens together so the subject
is in the focus and the picture is clear.
V- Screw the mount lens fixing screw.
(8) When using an auto iris lens , connect the enclosed miniature
4 pins plug following the diagram and plug the connector
into the socket Rep:6. When using an auto iris lens, the switch
Rep:5 should be in OFF position. When using a manual lens ,
this switch should be in ON position.
(9) Mount the camera on the mounting bracket with a l/4-20 screw.
PACKING
1 Camera
1 L Wrench
1 Connector 4 pins for auto iris lens
1 Javelin instruction manual
Page4
Advertisement
