Summary of Contents for FLEXPOWER FLEXC II-12PX
- Page 1 INSTRUCTION MANUAL MODEL NO.: FLEXC II-12PX FLEXC II-9PX FLEXC II-6PX FLEXC II-3PX 18V Brushless Cordless Torque Screwdrivers Rev 1. 5/18/2012 www.mountztorque.com...
-
Page 2: Functional Guides
FUNCTIONAL GUIDES (A) 1/4" F/Hex with quick change chuck (B) Color Ring - color code specific torque values in production areas. (C) Torque adjustment cover (D) LED indicator provides simple process information to the operator (E) LED light for working in dark area (F) Trigger repeat protection. -
Page 3: General Safety Rules
WARNING! "READ ALL INSTRUCTIONS" Always observe the safety regulations applicable in your country to reduce the risk of fire, electric shock and personal injury. Understand the following safety instructions before attempting to operate this product. Always wear eye protection when working with power tools. Keep these instructions in a safe place. - Page 4 Use only accessories that are Make sure cord for charger is located recommended by the manufacture so that it will not be stepped on, for your model. Accessories that tripped on, tripped over, or otherwise may be suitable for one tool, may subjected to damage or stress.
-
Page 5: Functional Description
Do not store the machine and 3. Forward/Reverse Button battery pack in locations where the The tool is always in forward temperature may reach or exceed operation unless the C (122 Forward/Reverse button is pressed. Do not incinerate the battery pack When the button is pressed, the blue even if it is severely damaged or LED shows and the tool will be in... - Page 6 OPERATIONS ASSEMBLY This product had been carefully inspected prior to leaving the factory. It Check for damage to the tool; parts or should provide you with years of accessories that may have occurred satisfying service under normal during shipping. Take the time to operating conditions.
-
Page 7: Led Indicator
Steps for Torque Adjustment Forward/ Reverse Rotation Switch Operation 1. Lift the torque adjustment over. Take To prevent damage, do not press the torque adjust tool and insert it to Forward/Reverse button until the anvil the quick change holder and turn comes a complete stop. - Page 8 Charging the battery - 4. If the power lamp (red) does not for Li-ion battery light immediately or goes out soon [NOTE] after the charger is plugged in, When charging a cool battery pack consult an authorized service (below 0 C (32 F) in a warm place, center.
- Page 9 Set @ 1,550 RPM FLEXC II-6PX 1,650 Set @ 6 N.m Set @ 900 RPM FLEXC II-9PX 1,943 Set @ 9 N.m Set @ 700 RPM FLEXC II-12PX 1,666 Set @ 12 N.m Set @ 550 RPM - 9 -...
-
Page 10: Lamp Indications
LAMP INDICATIONS Red Light Charger is plugged into the AC outlet. Ready to charge. Yellow Flashing (1) When the temperature of the battery is too low (<0 C(<32 F)), it is in a trickle charge mode until the temperature of the battery goes up to over 0 C(<32 The lamp will change from the Yellow Flashing to Green Flashing automatically and start to charge. -
Page 11: Specifications
203 mm (8”) Battery Type Li-ion 1.5A.h Li-ion 1.5A.h Charge Time Approx. 40 mins Approx. 40 mins MODEL FLEXC II-9PX FLEXC II-12PX ITEM Voltage 18 VDC 18 VDC Drive Size 6.35 mm Hex. (1/4”) 6.35 mm Hex. (1/4”) Screw Size... - Page 12 CLUTCH UNITS For Models: FLEXC II-3PX FLEXC II-6PX FLEXC II-9PX FLEXC II-12PX Index Index Index Description Q'ty Description Q'ty Description Q'ty Clutch Assembly Spring Snap Ring Steel Ball Adjust Washer Quick Change Holder Steel Ball Adjust Nut Spring Washer Snap Ring...
- Page 13 GEAR BOX UNITS For Model: FLEXC II-3PX Index Index Index Description Q’ty Description Q’ty Description Q’ty Inverted Retaining Ring Gear Cage Assembly Gear Box Assembly Washer Gear Plate Assembly (1) O-ring Planet Gear (2)Ball Bearing For Model: FLEXC II-6PX Index Index Index Description...
- Page 14 Description Q’ty Inverted Retaining Ring Gear Cage Assembly Gear Box Assembly Washer Planet Gear (1) O-ring Planet Gear Gear Plate Assembly (2)Ball Bearing For Model: FLEXC II-12PX Index Index Index Description Q’ty Description Q’ty Description Q’ty Inverted Retaining Ring Gear Cage Assembly...
- Page 15 HOUSING & MOTOR For Models: FLEXC II-3PX FLEXC II-6PX FLEXC II-9PX FLEXC II-12PX Index Index Index Description Q'ty Description Q'ty Description Q'ty Upper Housing O-Ring 18V Li-ion 1.5Ah Battery Lower Housing Motor Holder Cover Cover Screw Suspension Bail Marking Ring...
-
Page 16: Service Centers
Service Centers Corporate Headquarters & Service Center 1080 North 11th Street, San Jose, CA 95112 Phone: (800) 456-1828 Fax: (408) 292-2733 Distribution & Service Center 19051 Underwood Road, Foley, AL 36535 Phone: (251) 943-4125 Fax: (251) 943-4979 Mexico Mountz Mexico SA de CV Ave.