Basic Operations; Plug And Play (For Tuner Installlation); Switching The System On/Off; Power Saving Automatic Standby - Philips PDCC-JH-0811 User Manual

IMPORTANT!
– Before you operate the system,
complete the connection procedures.
– When the system is switched to
Standby mode, it is still consuming
power.To disconnect the system from the
power supply completely, reomve the AC
power plug from the wall socket.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY " is displayed.
2
Press ÉÅ on the system to start installation.
➜ "PLUG AND PLAY" .... "INSTALL" is
displayed, followed by "TUNER" and "AUTO".
➜
starts flashing.
PROG
➜
The system will automatically store the radio
stations (FM only ) with sufficient signal strength.
➜
When all the available radio stations are
stored or the memory for 20 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
1
In standby mode, press and holdÉÅ on the
system until "AUTO INSTALL - PRESS
PLAY" is displayed.
2
Press ÉÅ again to start installation.
➜
All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
● Press 9 on the system.
➜
If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
(for tuner installlation)

Basic Operations

Switching the system on/off

●
In standby/Eco-power standby mode, press
STANDBY-ONB or SOURCE on the set,
or DISC, USB, FM or AUX on the remote to
switch on the system.
➜
The system will switch to the selected or last
selected source.
To switch the system to standby mode
●
In power-on mode, press briefly STANDBY-
ONB (B on the remote).
➜
The clock time will be displayed. Or "--:--"
will be displayed if clock time is not set.
To switch the system to Eco-power
standby mode
●
In power-on mode, press and hold STANDBY-
ONB (B on the remote).
➜
"ECO POWER" is displayed briefly.
➜
Eco-power lamp B on the front panel will
light up.
➜
The LCD display will go blank.
Helpful hints:
– Pressing and holding B on the remote can
switch between Eco-power standby and normal
standby.

Power saving automatic standby

As a power-saving feature, the system will
automatically switch to Standby mode if you
don't press any button within 15 minutes in the
stop mode.
19