Warranty; Supply Of Combustion Air - Omega User Manual

Installation distances from non-combustible walls.
We recommend a 50mm minimum distance to non-combustible materials for the sake of cleaning. The
cleanout door should always be accessible.

3. Warranty

Jydepejsen warrants brand new wood-burning stoves for 5 years. The warranty covers:

Production defects.

Fire-penetration of the steel, assuming that the stove has been fired up correctly.
In case you have questions or require servicing during the warranty period, please contact your dealer who will assist you.
Always inform the dealer of which model you have purchased as well as the serial number of your stove. The serial number
is located on the data plate on the rear of the stove.
The following are not covered by the warranty:

Transportation damages.

Secondary damages resulting from the use of the stove.

Damages resulting from incorrect use such as superheating. Such damages may be avoided by following the
operating manual instructions.

Glass, soapstone, sandstone and ceramics
If the chips are down and your stove needs repairing under the warranty, you must be able to present a dated and signed
invoice stating the name of the dealer and the model. In case of repairs under the warranty, the parts and labor costs will be
covered by Jydepejsen A/S. Other costs such as dismounting and remounting of the chimney will be covered by
appointment with Jydepejsen A/S only.
The stove has parts that are subjected to inherent wear and tear. Such parts are not covered by the warranty and you will
have to replace such parts over time. How often depends on the use of the stove.
The following parts on your stove are wearing parts:

Vermiculite plates

Baffle plates

Sealing bands
If these parts need replacing, you may order them from your dealer - please refer to the Maintenance section.
4. Supply of combustion air (optional)
When a wood-burning stove is installed in a room, the air supply requirements change. Air may be supplied indirectly via a
valve in the outer wall or via an external canal by connecting a connecting piece to the bottom section of the stove. The
connecting piece o.d. is Ø 100mm. The hot parts of the canal should be insulated against condensation, e.g. with 25mm
mineral wool with a moisture barrier on the outer face. Installing the stove, you should use joint filler to seal the pipe / wall
interface.
Through the bottom plate:
Use a hammer and/or screwdriver to remove the plug in the bottom plate / back plate.
Through the back plate: