Advertisement
ADX-140 Specifications
Microphone Inputs
Preamp Gain (total path)
Freq Response
Microphone Channel EIN
System Signal/Noise
Distortion
Microphone Preamps
A-D and D-A Conversion
Digital Processing
Cobranet Transmission
Sample Frequency
Path Latency
IFB 1 Output
IFB 2 Output
PL Interface at ADX-140
PL Interface (Truck End)
PL Trans-hybrid Loss
Remote Control
Front Panel Switches
System Addressing
Bundle Numbers
Power Requirements
Power Source
Ethernet Interface
Ethernet Bandwidth Req'd
Dimensions
4 low-impedence balanced. Phantom power available
+25dB to +70dB
20-20KHz, +/- 0.5 dB
>125 dB, bandwidth-limited to 25KHz, at 60dB gain
>100 dB below peak level, bandwidth-limited to 25KHz
<0.05% for Mic/Line and Dry IFB. <0.12% for PL / Wet IFB
THAT Corporation 1570 / 5171
24-bit
Dual-core 32-bit dsp
20-bit uncompressed
48 kHz
Approx 2.25 Milliseconds on all paths (analog to analog)
2 channel wet RTS-format or single-channel dry +4dB nom.
2 channel wet RTS-format or single-channel dry +4dB nom.
2 channel wet RTS-format. DC current to support 3 beltpacks
4-wire dry +4dBm nominal. 8 assignable 4W Ports
Greater than 55 dB at 440Hz
From ADX-2400 front panel or via RS232 Remote connector
System ID two-digit rotary switches
Rear panel two-digit rotary switches. Address 01-99
Set automatically based on System Address
48 Volts DC, 255 ma. 420 ma with four RTS/Telex beltpacks.
48V on spare Cat5 pairs, and/or AC Line (95-250VAC, 50/60Hz)
100baseT Standard Ethernet (redundant RJ45 ports)
Approximately 8 megabits each direction per ADX-140
19" wide x 9" deep x 1.75" high (1RU) Weight approx. 3.5 lbs
18
Advertisement
