Subscribe to Our Youtube Channel
Summary of Contents for Klom WL314
- Page 2 © Wilton 2013 No part of this report may be reproduced or transmitted in any form whatsoever, electronic, or mechanical, including photocopying, recording, or by any informational storage or retrieval system without express written, dated and signed permission from the author.
- Page 3 Therefore, this guide has been produced to help you to get the best results from the Klom electronic pick gun and to ensure that you are opening locks with it in the shortest time possible.
- Page 4 Note: - The Klom Electric Pick Gun can be purchased from www.withoutakey.co.uk...
- Page 6 Parts of a KLOM EPG Buy the KLOM EPG from Withoutakey.co.uk...
- Page 7 Before you do anything with the Klom it is recommended that you carry out the following steps. The first thing that you will need to do after receiving your Klom EPG is to get it fully charged. Once you plug the charger in to an adapter and set it charging you will notice a red light on the charger unit.
- Page 8 Once the Klom has fully charged you can now attach the head piece to the body. By looking at the head and the end of the Klom you should be able to see how the two parts align. You will need to twist the head into place and you simply reverse this motion when you want to remove the head section.
- Page 9 Push the sliding direction bar fully to the left or right. The side that you push this to doesn't matter when the normal head is attached. The direction is only relevant if the drill head is attached. For the normal head that creates the up and down motion the direction that the drive mechanism moves in is not relevant because either way the mechanism will still go up...
- Page 10 Technique...
- Page 11 Remember that practice makes perfect and this is also true in respect to the Klom Electronic Pick Gun. You must practice using the tool to get used to handling it and to learn the correct feel and touch to ensure rapid results when using it.
- Page 12 The next thing I always like to do is to insert the turning tool that I’ll be using into the lock first. This helps you to see that it will not interrupt the use of probe of the lock gun. It is important to have a correct sized turning tool.
- Page 13 The next step is to insert the actual probe of the lock gun. It is important here to ensure that the probe does actually reach all the way to the pin stack at the back of the lock. It is no good picking 4 out of the 5 pins and not picking that last pin stack.
-
Page 14: Hints And Tips
Hints & Tips... - Page 15 Pushing the bar from one extreme position to the other changes the direction of rotation of the KLOM. If this bar is in a interim position the KLOM may not function. Make sure it it pushed fully to one side or the other.
-
Page 16: Troubleshooting
Troubleshooting... - Page 17 3) If the gun is not picking the lock. Remember that the Klom EPG is a tool and just like any other tool you need to practice to use it effectively. Do not expect the Klom to take all the skill out of lock picking.
- Page 18 This is a symptom of a poor charge of the gun. See the above and plug the Klom in for a full charge. Also, ensure that the direction lever is moved fully over to the left or the right of the gun.
- Page 19 I also hope very much that you have enjoyed this guide and if so please do email to let me have your comments. Also, please check out the further guides available in this series (available at WithoutaKey.co.uk). Contact me at pete@withoutakey.co.uk Best Wishes Pete Buy the KLOM EPG from Withoutakey.co.uk...
Need help?
Do you have a question about the WL314 and is the answer not in the manual?
Questions and answers