Table of Contents
Advertisement
SETTING UP THE CAMERA
USING THE AC ADAPTER (Sold Separately)
The AC Adapter allows the camera to be powered from an electrical household outlet.
During periods of heavy use, the AC adapter can conserve battery power. Its use is
recommended when the camera is connected to a computer.
Do not change the power supply while the camera is on. Always turn off the
camera before changing between battery and AC operation.
Insert the mini plug into the
camera's DC terminal.
Insert the AC plug into an electrical
outlet.
• The camera can now be turned on.
ATTACHING THE CAMERA STRAP
Insert the smaller loop of the strap
through the strap eyelet.
Pull the other end of the strap
through the small loop and tighten.
• The shape of the mini plug can vary with the
AC adapter model.
- 22 -
SETTING UP THE CAMERA
INSERTING THE COMPACTFLASH CARD
A CompactFlash card must be inserted for the camera to operate. If a card has not
been inserted, "CF" will appear on the data panel and a no-card warning will be dis-
played on the LCD monitor.
Always turn off the camera before inserting or removing a CompactFlash card
otherwise the data on the card could be lost, and the card may be damaged.
Open the battery/card chamber
door by sliding it in the direction
indicated (1), then open the door
(2).
Insert the CompactFlash card into
the card slot until the card-release
lever pops out.
Fold the card-release lever down
as shown.
Fold the battery/card chamber door
down (1) and slide it slightly toward
the front of the camera. Then, while
pressing down, slide it back to the
rear of the camera (2) until it clicks.
• Insert the card so the face is toward the
back of the camera. Always push the card in
straight, never at an angle. Never force the
card. If the card does not fit, check its
orientation.
- 23 -
Advertisement
Table of Contents
