Summary of Contents for Appliance AGH 7000
- Page 1 AGH 7000 BRUGSANVISNING BRUKSANVISNING BRUKSANVISNING KÄYTTÖOHJE OPERATING MANUAL...
- Page 3 A GH-7000 25-30 USER MANUAL 03 -07 BRUGERVEJLEDNING 08-13 ANVÄNDARHANDBOK 14- 19 BRUKSANVISNING 2 0- 24 KÄYTTÖOHJE AGH-7000 The features described in this manual are published with reservation to modifications. Vi forbeholder os retten til ændringer af de specifikationer, der er beskrevet i denne brugsanvisning. Funktionerna i denna bruksanvisning publiceras med reservation för ändringar.
-
Page 4: Table Of Contents
Fan: 130m³/h * Including folding base plate This heater is constructed in conformity with the EN 449:2002 standard and the applicable Gas Appliance Directive (GAD) 90/396/EEC as last modified by Directive 93/68/EEC. The electrical components comply with the relevant EMC and LVD requirements. -
Page 5: Assembling The Gas Heater
• This appliance is not intended for use by children, or persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety . - Page 6 Please the heater lying on the ground on a soft rug (as showed in fig. 1), remove two of the wing nuts, pull out the extension panel, let the screw holes of bottom panel consist with the screw holes of extension panel, then fix the winged nuts according to primary installing way (as showed Fig.2).
-
Page 7: Installation
Installation Use the gas heater in well-ventilated rooms only. A room size of 85m³ - 45 m³ (~40 – 20m²) is recommended and the room should never be smaller than 20m³ (~10m²). The room in which the gas heater is used should have enough air circulation for normal combustion. Therefore it is recommended that the room must draw at least through an opening of 100 cm²... -
Page 8: Gas Leaks
Electrical heater switches Electrical heater switch pushed down: “I and II” – ON “O” – OFF While the fan is running, press one or two switches; one switch ‘on‘ is 1 kW, both switches ‘on’ is 2kW heat output. IMPORTANT: The fan must be ‘on’ to achieve heat output from the electrical heater. Fan switch Two switches for electrical heater Figure 5. -
Page 9: Cleaning And Maintenance
4. Find out the fuse house (fig. 4), loosen it according to the showed arrow direction; 5. Take out the fuse tube, replace it with a well fitting 10A one; 6. Fix the cover protecting wires with the cross screwdriver; 7. -
Page 10: Warranty Provisions
When the appliance is no longer functional, it should be disposed of in such a way as to cause minimum environmental impact, in accordance with the regulations of your local authority. - Page 11 When the appliance is no longer functional, it should be disposed of in such a way as to cause minimum environmental impact, in accordance with the regulations of you local authority.
- Page 12 DISTRIBUTED IN EUROPE BY APPLIANCE A/S i ÖSTERREICH 4 UNITED KINGDOM PVG Austria VertriebsgmbH Scott Brothers Ltd. Salaberg 49 The Old Barn, Holly House Estate 3350 HAAG Cranage, Middlewich, CW10 9LT UK tel: +43 7434 44867 tel.: +44 1606 837787...
Need help?
Do you have a question about the AGH 7000 and is the answer not in the manual?
Questions and answers