Marantz NR1604 Model Information page 10

Important: Back up the settings before resetting the microprocessor. Most settings are reset to the factory default values after
performing this procedure. This means that all the settings data will be completely lost if it's not previously saved.
Reset procedure:
With the power off, press and hold the "M-DAX"
button, "ZONE 2 SOURCE" button, and "POWER"
button simultaneously on the AVR for a few
seconds until "INITIALIZED" appears on the
AVR's display
Resetting the micro is a procedure used to "reboot" the microprocessor to restore its
normal operation when it temporarily freezes, locks up, or behaves erratically. Resetting
the microprocessor, erases any saved settings you may have previously programmed
into the unit Issues that can affect the performance of the microprocessor:
•
A jolt of static electricity
•
Current surge through an input
Before resetting the microprocessor;
•
Check all connections carefully
•
Check for setup errors
• Back up your settings. You may also want to write down your preferred settings for easier task of setting up the AVR after reset.
Note: The Web (Browser) Control feature can be used to back up your settings by saving a configuration file on your hard drive. For this
feature, we recommend using one of the following web browsers: Internet Explorer 10 and above, Mozilla Firefox 24 and above, Google
Chrome 29 and above, and Safari 5.x and above.
Note: If you had an installer setup your system, please first contact your installer to see if they can reset and then setup your system again
as there may be specific EQ calibrations (Audyssey) that the installer will need to perform.
WARRANTY 2
Reset
"M-DAX" button
Power/Standby
button
HOME
"ZONE2
SOURCE" button
ACCESSORIES
10