Axis P3364–VE Installation Manual page 19

1
Mounting bracket
2
Network cable with gasket
3 Unit casing
4
Wall gasket
5
Bottom gasket
6
Spring
Route the Cables through the Wall
1. Drill four holes in the wall using the drill template.
2. Route the network cable and, if required, the I/O and audio cables through the wall and
through the holes in the mounting bracket.
3. Attach the mounting bracket to the wall using four screws and plugs appropriate for
the wall material.
4. Remove the camera unit from the unit casing by pushing the springs apart.
5. Remove the wall gaskets from the unit casing. If there is only one cable, remove only
one gasket.
6. Route the cables through the wall holes in the unit casing.
7. Drag the gaskets along the cables and plug them into the holes. The gaskets should fit
snugly in the holes with no folds or bends.
8. Attach the unit casing to the mounting bracket by tightening the four screws.
Prepare the Unit Casing
If the cables are to be routed along the wall, prepare the unit casing as follows:
AXIS P33–VE Network Camera Series
19