Summary of Contents for AirBench MF600
-
Page 1: Operation And Maintenance
AIRBENCH LTD AirBench™ MF600 Operation and Maintenance This Edition: 6 September 2016 AirBench Ltd, 14 Grange Farm Road, Colchester CO2 8JW www.airbench.com +44 (0) 1206 791191 Page ! of ! -
Page 2: Table Of Contents
CONTENTS Contents Note DIRECTIONS FOR USE Prior to Use PREPARATION INSTALLATION ELECTRICAL CONNECTIONS Operation PRINCIPLE OF OPERATION CONTROLS FILTER REPLACEMENT LOG BOOK FILTER ACCESS FAULT FINDING Support DECLARATION OF CONFORMITY Page ! of ! -
Page 3: Note
" • The MF600 must not be used in an environment where there is a risk of explosion from dust or gases in explosive concentrations The MF600 must only be used for the designated application. Contact us before change of use. -
Page 4: Prior To Use
PRIOR TO USE PREPARATION Immediately upon receiving the MF600, examine the packaging for any damage that may have occurred during shipment. In the event of any damage please contact the supplier immediately. INSTALLATION This unit weighs approximately 60kg. The unit must be installed on a suitable level floor or mount that is able to support its weight. -
Page 5: Operation
OPERATION PRINCIPLE OF OPERATION The MF600 is supplied with: • EU4 Pre Filter • F8 Bag Filter • Centrifugal fan assembly Air is drawn through the two filters at the inlet and the clean air expelled at the outlet. CONTROLS All electrical equipment and controls are located in the electrical enclosure. -
Page 6: Filter Access
MF600. • Use necessary PPE " SUPPORT Contact your supplier, or the manufacturer: AIRBENCH LIMITED, 14 GRANGE FARM ROAD, COLCHESTER, ESSEX, CO2 8JW, UK Tel: 01206 791191 Fax: 01206 791091 Web: www.airbench.com Email: sales@airbench.com Page ! of ! -
Page 7: Declaration Of Conformity
- EN-60204–1:2006 (Safety of machinery, electrical equipment of machines, general requirements). - EN-60335-2-80 (Safety requirements for electric fans and regulators). We; AIRBENCH Limited, declare that “MF600” when supplied as self contained equipment complies with the directives detailed above and therefore comply with requirements of the Low Voltage Directive.
Need help?
Do you have a question about the MF600 and is the answer not in the manual?
Questions and answers