Advertisement
Quick Links
INBIKE 528 Bike Computer Instruction
Fuctions
SPD
Speed
Odo Total cycling distance
One-pass cycling distance
Maximum speed
Average speed
AVS
One-pass cycling time
TM
CLK
Clock
Automatic Cycleplay
SCAN
BACKLIGHT
SW
Stop-watch
Count-down distance
CDD
Count-down time
CDT
Consumed calorie
CAL
Consumed fat
FAT
Temperture
TEM
Power saving
'+'& '-' Speed comparing
Upkeep reminding
KM/hr M/hr setting
Total distance initial value setting
Automotive wake-up
Installation of Battery
Open the battery lid with a coin. Put in a 3V CR2032 Battery. ( Positive pole upwards)
Installation of inductor & Magnet
Install the Inductor on the front fork ( Same side as the magnet),Fix the inductor with the
complimentary armor tape, twine the wire on the handlebar.(Fix with armor
tape) ,Adjust the position between the magnet and inductor, make the distance around
1.5mm.(The closer ,the Better) .When fix the magnet, never let the magnet towards the
centre of inductor, make the magnet towards to the upside or downside of the inductor.
Installation of the computer base
Fix with the armor tape
Advertisement
Summary of Contents for Inbike 528
- Page 1 INBIKE 528 Bike Computer Instruction Fuctions Speed ODO Total cycling distance One-pass cycling distance Maximum speed Average speed One-pass cycling time Clock Automatic Cycleplay SCAN BACKLIGHT Stop-watch Count-down distance ...
- Page 2 Installation of the computer Press the computer into the base, Rotate clockwise. Wheel perimeter setting 1. Record the size marked on the wheel , find out the perimeter by referring to the follow chart 2. Draw a spot on the wheel, then push the bike, The distance is the wheel perimeter when the spot runs a circle.
- Page 3 Clock setting( 12/24 hr) Press left button 3 seconds to set 12/24hr mode. Press left button to switch 12hr/24hr. Press right button to set the hour, press right button to adjust the number. Left button adjust the number. Right button confirm.
- Page 4 (CDD) Count-down distance Press left button 3 seconds to begin count-down distance setting, Left button adjust the number. Right button confirm. Press the right button to view CDT. (CDT) Count-down time Press left button 3 seconds to begin count-down time setting, Left button adjust the number.
- Page 5 Resetting Press both left and right button 3 seconds to reset distance unit(KM/M) , wheel perimeter, weight & upkeep remind distance. The original date will be kept. Current speed The current speed will show at the top position. Speed comparing ...