Do you have a question about the SX.COM 2 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for Nexx SX.COM 2
Page 1
Bluetooth ® Headset & Intercom for Scooters and Motorcycles User's Guide www.nexx-helmets.com...
Page 2
Sena Technologies, Inc reserves the right to make any changes and improvements to its product without providing prior notice. Sena is a trademark of Sena Technologies, Inc. or its subsidiaries in the USA and other countries. 20S , PRISM , Snowtalk , SX.COM 2 , SMH10 ™ ™ ™...
• Bluetooth stereo headset for Bluetooth stereo devices such as MP3 players Thank you for choosing the NEXX SX.COM 2, Bluetooth Headset and • Bluetooth stereo headset for Bluetooth GPS navigations Intercom for Scooters and Motorcycles. With the SX.COM 2, you can •...
SX.COM 2 2. PACKAGE CONTENTS Status LED (–) Button Pin-hole (Intercom) Reset Button USB Power & Data Cable Speakers (+) Button (Phone, Music) Microphone Sponges Hook and Loop Fasteners Microphone for Speakers DC Power Charging & Firmware Upgrade Port...
SX.COM 2 3. GETTING STARTED Installing the SX.COM 2 on Your Helmet 1.Peel off the hook fasteners for the speakers and attach them on the back sides of the speakers. 2. Attach the loop fasteners for the speakers in the deep ear pockets of...
Page 7
SX.COM 2 3. Place the speakers in the helmet along with the hook and loop fasteners, centered to your ear. 4. Locate the microphone as closely as possible to your mouth when wearing the helmet. 5. Hide the wire under the helmet padding after the installation...
Press and hold the (+) Button and the (–) Button at the same time for 1 You can charge the SX.COM 2 by connecting the supplied USB power & second to power on. The blue LED turns on and you will hear ascending data cable into a computer USB port or USB wall charger.
1. The USB power & data cable is also used for fir mware upgrade Button and (–) Button simultaneously for about 3 seconds until you hear of the SX.COM 2. three high tone beeps. Then you will hear a voice prompt indicating the 2.
Fault Reset Adjusting the Volume Level When the SX.COM 2 is not working properly or is in faulty status for any You can easily adjust the volume by pressing the (+) Button or the reason, you may reset by pushing the pin-hole reset button on the left (–) Button.
4. OPERATION QUICK REFERENCE 5 sec. Sena 3S v1.1 Function Operations 1 sec. 1 sec. 1 press 1 press Bluetooth Power Select NEXX SX.COM 2 On/Off Pairing (Phone, MP3, Power On Power Off GPS) 1 press 1 press Sena 3S v1.1 Volume Sena 3S v1.1...
Page 12
SX.COM 2 Operations Function Operations Function 1 press 1 sec. Answer 2 sec. 2 sec. Music 3 sec. 2 sec. Mobile Phone Voice Dial 3 sec. * You can use “Voice Dial” and “Redial” only in stand-by mode. 2 sec.
You can simultaneously use two mobile phones which use the mobile BLUETOOTH DEVICES phone profile. 1. You can pair the first mobile phone to the SX.COM 2 by following the Mobile Phone Pairing simple procedures in “Mobile Phone Pairing”. 2. To pair the second mobile phone, press and hold the (–) Button for 1 Turn on the SX.COM 2 and press and hold the (+) Button for 5...
1. If the Bluetooth stereo device is integrated with the mobile phone such as smartphones, you don’t need to pair the SX.COM 2 with it separately. When the SX.COM 2 is paired with the mobile phone, it is...
Page 15
Pairing Pairing 3. Search for Bluetooth devices on the GPS navigation screen. Select the NEXX SX.COM 2 in the list of the devices detected on the GPS. A2DP 4. Enter 0000 for the PIN. 5. The GPS confirms that pairing has completed and the SX.COM 2 is ready to use.
Page 16
Bluetooth stereo music source, you can pair the GPS to the SX.COM 2 by following the simple procedures in “Mobile Phone Pairing”. When you do this, the SX.COM 2 thinks the GPS is a mobile phone. But the SX.COM 2 can directly pair an additional mobile phone.
Audio/Video Remote Control Profile (AVRCP), so if your Bluetooth • Enter numbers on your mobile phone keypad and make a call. audio device also supports the AVRCP, you can use the SX.COM 2 to Then the call is automatically transferred to the headset.
1. When you have an incoming mobile phone call during an intercom 1. Turn on the two SX.COM 2 headsets (A and B) that you would like to conversation, you will hear a ring tone. You can choose whether to 1) pair with each other.
(–) Button. If your intercom friend goes out of range while having an intercom 4. If any button is not pressed within 10 seconds, the SX.COM 2 will exit conversation, you may hear static noise and eventually the intercom the configuration and goes back to standby.
VOX feature does not work if you are connected to intercom. To delete all Bluetooth pairing information of the SX.COM 2, press and This is enabled from the factory but you can disable this. If this mode is hold the (+) Button until you hear a voice prompt, “Delete all pairings”,...
(+) Button until you hear a voice prompt, “Factory reset”. Press the “Exit configuration” Execute (–) Button to confirm. The SX.COM 2 powers off with a voice prompt, Voice Configuration Menu & Button Operations “Headset reset, goodbye”. Exit Voice Configuration Menu Voice Prompt “Exit configuration”...
SX.COM 2 8. FIRMWARE UPGRADE The SX.COM 2 supports firmware upgrade function. Please visit Nexxpro, S.A. Bluetooth web site at www.nexx-helmets.com to check the latest software downloads.
SX.COM 2 BATTERY INFORMATION MAINTENANCE AND CARE The product has an internal, non-removable, rechargeable battery. Do The product should be treated with care and the following suggestions not attempt to remove the battery from the device as you may damage will help you protect your warranty coverage.
SX.COM 2 CERTIFICATION AND SAFETY APPROVALS DISPOSAL The crossed-out wheel bin symbol on the product, FCC Compliance Statement literature, or packaging reminds you that all electrical and This device complies with part 15 of the FCC Rules. Operation is subject...
SX.COM 2 • Connect the equipment into an outlet on a circuit different from that to is intended to be used in Austria, Belgium, Denmark, Finland, France, which the receiver is connected. Germany, Greece, Ireland, Italy, Luxembourg, The Netherlands, • Consult the dealer or an experienced radio/TV technician for help.
Officers, Directors, Affiliates, Parent Company, Representatives, Agents, Contractors, Sponsors, Employees, Suppliers and Resellers NEXX and Sena hereby notifies you that using this Device may also be in (jointly referred to as the “Company” or “Sena”) strongly advise you to...
Device. 4. You fully acknowledge our warnings and understand that: (a) risks This warranty is limited to the repair and/or replacement, at NEXX ’s and dangers exist in using the Device while in traffic, including but...
NOT LIMITED TO, LOSS OF ANTICIPATED PROFITS OR BENEFITS RESULTING FROM, OR ARISING OUT OF, OR IN CONNECTION WITH NEXX informs that using this device in public traffic may not be THE USE OF FURNISHING OF EQUIPMENT, PARTS OR SERVICES authorized by the law.
Page 29
SX.COM 2 www.nexx-helmets.com User's Guide for Firmware v1.1...
Need help?
Do you have a question about the SX.COM 2 and is the answer not in the manual?
Questions and answers