Menu..........21 Troubleshooting ......38 Adjusting the display brightness ........ 22 Index ..........40 Resetting the KB 62 CR Technical Data ......42 to the default settings ..... 22 Loading new system software .. 22 Accessing the version of the system software....22 Leaving the menu ....
Technologies International, Ltd. way constitutes any liability on the Qualcomm is a trademark of Qualcomm part of Lautsprecher Teufel GmbH. Incorporated, which is registered in the No part of these instructions may USA and other countries; its use has been be reproduced in any form or be approved.
Complaints Proper use In case of a complaint we will need The KB 62 CR is designed for the play- the following information to process back of music and speech via FM/ your enquiry: DAB+ radio, CD, USB, Bluetooth or an external player.
Page 5
*) labelled with: the environment. Cd = cadmium, For this reason, electrical Hg = mercury, Pb = lead equipment is marked with the adjacent symbol. • KB 62 CR...
– Never touch the mains plug with mains cord is defective or exhibits wet hands. other visible damages. – If the mains cord is damaged, replace it with an equivalent one. • KB 62 CR...
Page 7
This may have psychic conse- quences and also cause physical injury. Children and pets are particularly at risk. Set the volume control to a low setting before you turn the device on. • KB 62 CR...
Page 8
If the device is subjected to warm temperatures after being cold (e.g. after transport), condensation may occur inside of it. – In this case, wait at least 2 hours before you connect and activate it. • KB 62 CR...
Overview Unpacking – Carefully open the box and carefully lift the KB 62 CR with the EPE foam parts out. Pack contents ① 1× CD receiver KB 62 CR ① ② 1× remote control KB 62 RC ③ 1× mains cord for ①...
Control Elements And Connections Front side 15 14 12 11 10 Back side 20 21 • KB 62 CR...
Page 11
20 Charging port for USB devices 26 AUX 1 input jacks 21 Port for headphones 27 REC output jacks 22 Optical digital input 28 Connection for active subwoofer 29 Turn the device on/off 30 Jack for mains cord ③ • KB 62 CR...
44 Set the sleep time 45 Reduce the volume 46 Selector button, start/pause playback 47 Left, CD + USB: Press: Skip, Press and hold: Fast rewind Radio: Setting a station 48 Display menu 49 Power on/Standby • KB 62 CR...
For this, you will have to point the front rechargeable batteries to of the remote control towards the direct sunlight. KB 62 CR. Make sure that the infrared light is not obstructed by objects. • KB 62 CR...
– With the enclosed antenna adapter ⑥, you can also connect the KB 62 CR with a cable connection, but it is not possible to receive DAB+ with it. • KB 62 CR...
Inputs for source devices Record player Most record players can be connected Analogue sources to one of the aforementioned The KB 62 CR offers three inputs for analogue inputs. analogue audio sources: The usually more expensive magnetic • AUX 1 (MM –...
You will need a stereo cable with RCA plugs to do so. Headphones With the KB 62 CR, you can connect stereo headphones to two jacks: 2. Turn the connector terminal (23) • Jack (7) on the front side for 3.5 counterclockwise until loose.
Risk of injury/damage! – Lower the volume before you pull the headphone plug out again; otherwise, the speak- ers may emit unexpected high sound pressure. This could injure your hearing or damage the device. • KB 62 CR...
(“OFF” position) and to standby (“ON”). When in standby, the POWER button (1) will be illumi- nated in red. – Turn the KB 62 CR on or to standby with the POWER button (1) or (49). After switching the device on, the last active audio source and volume will be set.
On the KB 62 CR, select the source with the buttons (2): • BT, CD, DAB+, FM and USB buttons as on the remote control. • Push the button EXT 1-5 several times to select the sources AUX 1, AUX 2, LINE IN, OPT and PHONO one after another.
Note: If there is not input for more than 3 seconds, the KB 62 CR returns to the display mode of the current audio source. 1. Push the BALANCE button (8) or the SOUND button (43) three times.
You can perform the following func- tions via the menu: • Adjust the brightness of the display (4), • reset the KB 62 CR to the default settings, • load new system software, 11 10 • access the version of the installed system software.
USB stick. the skip buttons (12/10): <Yes> – default settings 9. The KB 62 CR will switch off once <No> – cancel the software has been installed. 5. Confirm the selected option with 10. Pull out the USB stick.
The set frequency is shown on the display (4). If the station transmits an RDS signal, the name of the station and, if appli- cable, the radio text will appear on the display (4) after a few seconds. • KB 62 CR...
(station package), time/date, signal strength, programme type, block/frequency and sampling rate. Setting a station You can switch between the stations that were found using the navigation buttons ◄/► (47/35) or the skip buttons (12/10). • KB 62 CR...
Station memory The KB 62 CR can save 40 stations to FM and DAB each. You can conven- iently select the saved stations. Presetting stations manually – Setting a desired station. – Single-digit memory slots (1–9): Push and hold the number button 1...0 (38) with the number of the...
10 metres that is limited by walls and furnishings. If the connection is cut off, the KB 62 CR will attempt to re- establish a connection until you select another source. NOTICE Smartphone ®...
KB 62 CR. The message “BT Input Mode" will appear on the display (4). 3. If the KB 62 CR is not connected to an external player, pairing will start automatically and the message “Pairing” will appear on the display (4).
® Pairing via NFC Interruption of connection ® (Near Field Communication) If your KB 62 CR moves out of the is a transmission standard for the range of your external player, the Blue- ® wireless exchange of data over short tooth connection will be interrupted.
Playback The volume setting of the external player affects the volume of the KB 62 CR. 1. Use the BT button (2/32) to select ® Bluetooth as the source. ® 2. Turn on the Bluetooth function on your source device.
CD Mode Only use commercially-available CDs carrying one of the adjacent symbols. The KB 62 CR can read normal CDs with a diameter of 80 and 120 mm as well as music files in the audio CD, MP3, M4A and WMA formats saved on them.
– Interrupt/continue playback: Tap CD will be endlessly played back in button (11) or SELECT/ order. (46). • SHUFFLE ALL – all tracks on the CD will be played back in random order, playback will then stop. • KB 62 CR...
CD tray will eject to the front. 2. Carefully remove the CD. 3. Push the button (5/33). The CD tray will close. The CD tray will automatically close after approx. 60 seconds of inac- tivity. • KB 62 CR...
2. Insert the plug of your USB device into the USB port (14). The plug only fits the jack in one orientation. 3. The KB 62 CR will read the USB device. The message “Reading Files” will appear on the display.
Page 34
(10/35). Playback will occur at approx. 10 times the normal speed; the elapsed time for the track will appear on the display (4). To resume normal playback, release the button. – Stopping playback: Push the button (36). • KB 62 CR...
– Never remove the USB device • REPEAT ONE – the current track will be repeated endlessly. while the KB 62 CR is still • REPEAT ALL – all tracks on the CD accessing it! will be played back in order. After- wards, playback restarts with the 1.
Sleep Function This function allows the KB 62 CR to switch itself off after a preset period of time. 1. Start the desired playback. 2. Push the SLEEP button (44). The display will show the message “Sleep Off”. 3. Press the SLEEP button (44) again...
In case of stubborn marks, a mild soap solution may be used. – Do not use caustic cleaning products, white spirit, thin- ners, petrol or similar under any circumstances. Such cleaning agents may damage the delicate surface of the housing. • KB 62 CR...
“Teufel KB 62” as the Blue- ® tooth output device. ® Bluetooth connection Set up the KB 62 CR and/ impaired by another radio or external player in another system (e.g. cordless tele- location. Move to another room phone, Wi-Fi). to test.
Page 39
Connect an additional power the connected USB device is supply to the USB device. too high (> 1 A). The KB 62 CR is connected to Connect the KB 62 CR to the subwoofer a different power circuit from same power circuit.
Technical changes reserved! Lautsprecher Teufel GmbH hereby declares that the radio equipment “KB 62 CR“ is in accordance with the 2014/53/EC, 2014/30/EC and 2014/35/EC directives. The full text of the EU Declaration of Conformity is available at the following Internet address: www.teufelaudio.com/declaration-of-conformity.html...
Page 44
Please contact our customer service department with any questions, suggestions or complaints: Lautsprecher Teufel GmbH Phone: 00800 - 200 300 40 (toll-free) BIKINI Berlin Fax: +49 (0)30 - 300 930 930 Budapester Str. 44 www.teufelaudio.com 10787 Berlin (Germany) No responsibility is assumed for the correctness of this information.