ATN NVG-7 User Manual page 5

2) Insert the head /helmet mount
adapter to mounting bracket of NVG7,
then tighten adapter screw firmly.
3) Insert the top edge of the mount
under the keeper on the head/helmet
mount bracket and rotate downward
until the latch engages. To release
the mount from the helmet bracket,
press the release and pull forward
and down.
4) Align the adapter and the head /
helmet mount as shown on the figure.
Slide the goggles rearwards until the
alignment boss aligns with the align-
ment groove on the head /helmet
mount. Push until the goggles locks
into the head/helmet mount.
5) Place the head/helmet mount with
NVG-7 onto your head.
6) Adjust the eye relief distance by
press down on side lever and sliding
NVG7 fore or aft to obtain a full field-
of-view of the image. Reset the diop-
ter adjustment for best image.
The NVG-7 headset has a flip-up
mechanism. Rotate the tilt adgustment
lever and lift the unit up.
Head/helmet mount
adapter
Screw
Release
Tilt Adjustment Lever
Side lever
Mounting bracket
Keeper
Top edge
of mount
Mount
Latch
4