Connecting To Optional Equipment; Inserting Batteries Into The Remote Control; Switching On - Philips Dvd 733 Manual

Preparation
Connecting to Optional
Equipment
A digital component with a built-in MPEG 2 or
Dolby Digital™ decoder allows you to enjoy the
surround sound while producing the effect of
being in a movie theater or a concert hall.
The player outputs the surround sound signals
from the DIGITAL OUT COAXIAL connectors.
If your receiver has a MPEG 2 or Dolby
Digital™ decoder,
1
Connect the COAXIAL DIGITAL AUDIO OUT
of the DVD player to the COAXIAL DIGITAL
AUDIO IN on your receiver.
REAR
SPEAKERS
REAR
SPEAKERS
RECEIVER with
MPEG 2 or Dolby
Digital™ decoder
TO COAXIAL IN
CVBS
L
R
TV OUT
AUDIO COAXIAL
OUT
Notes:
– If the audio format of the digital output does
not match the capabilities of your receiver, the
receiver will produce a strong, distorted sound or
no sound at all.
– To see the selected audio format of the
current DVD in the Setup Menu, refer to "Setup
Menu".
– MP3 Audio is not available on the Digital
Output.
10
1
2
3
OR
TO VIDEO IN TO SCART IN
MAINS
1
2
3
4
Inserting batteries into the
Remote Control
Open the battery cover.
Insert batteries (AA size) with the correct
polarity as indicated by the + and - symbols
inside the battery compartment.
Close the cover.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed off properly
and kept away from children.
Using the Remote Control
Direct the remote control at the remote sensor
of the DVD player.
Do not drop the remote control.
Do not leave the remote control near extremely
hot or humid places.
Do not spill water or put anything wet on the
remote control.

Switching On

Connect the AC power cord to the power
outlet.
Switch on the TV and DVD player.
Set the TV to the correct Video IN channel. (eg.
EXT1, EXT2, AV1, AV2, AUDIO/VIDEO, etc.
(Refer to your TV owner's manual for detail)
The player display lights up and the default
screen appears on the TV.
If you are using an external equipment (eg. audio
system or receiver), turn them on and select the
appropriate input source that was used to
connect to the DVD player output. Refer to the
equipment owner's manual for details.
+
-
+ -
3139 246 11931