Summary of Contents for QERIDOO Sportrex1
- Page 1 User manual Sportrex1 – Q3000-LV Sportrex2 – Q6000-LV This product fulfils all safety requirements of the European standard for bicycles and bicycle trailers (DIN EN 15918).
-
Page 2: Table Of Contents
When not in use special notification. Inserting the wheels Maintenance intervals This documentation can be ordered from Qeridoo GmbH in other languages, or is available for Fitting the wheel guard Before every ride download on our website if already available. -
Page 3: Introduction
Requirements for the tow bar Sportrex1 & Sportrex2 Sportrex function. For Trailer mode, use a tow bar with coupler to connect the trailer to a suitable towing Permissible tow bar load range (on the coupler pocket) 3 –... -
Page 4: Safety Instructions
ƒ the back of the trailer for journeys in darkness or conditions of poor visibility. Qeridoo. Using other products relieves the manufacturer of liability. Before every journey, close the inner part of the 3-in-1 canopy so that the integrated insect ƒ... -
Page 5: Cycling With A Trailer
74 cm and the is 85 cm wide. Maintain a sufficient distance from ƒ Sportrex1 Sportrex2 obstacles and avoid routes that are too narrow. Always negotiate narrow points and bends slowly. Combined, the bicycle and trailer are at least 2.5 m long in total. Negotiate curves with wider ƒ... -
Page 6: Components And Control Elements
Product overview Product overview Components and control elements Components and control elements Side view Rear view Cabin (frame made from aluminium tubes Tow bar for Trailer mode Variable-height push handle (incl. hand Parking brake brake lever with weatherproof fabric cover) strap for Buggy and Walker mode as well Tow bar mount on the cabin frame with Pushbutton for adjusting the height of the... -
Page 7: Accessories
Sportrex Also pay attention to the door width at the place of installation: The is 75 cm wide Sportrex1 needs and the age of your children: with the wheel guards fitted and the is 85 cm wide. -
Page 8: Inserting The Wheels
Assembly Assembly Inserting the wheels Loosely screw the self-locking nut onto the thread. When doing this, make sure that the circular side of the nut is not against the thread. Place the cabin on one side to allow the wheel to be inserted more easily. Connect the second screw in the same way. -
Page 9: Tightening The Backrest
Assembly Assembly Tilt back the cabin and place it on its reverse side. This makes the lower cabin frame accessible Using the connecting piece, insert the pennant staff for assembly. into the extension rod. Insert the extended pennant staff into the pennant Hook the end of the brake cable into the opening of pouch on the outer left side. -
Page 10: Mounting The Coupler Onto A Bicycle
Assembly Assembly tow bar mount and folding down the securing bracket. Quick-release axle: Tighten the cap nut until you can close the clamp with a certain amount – of pressure. Tip! Full axle: Tighten the nut with a spanner. Always pay attention to the bicycle manufacturer’s –... -
Page 11: Utilisation
Utilisation Utilisation Setting the mode Below you will find all the information for adapting the to the required modes and to Sportrex allow you to use all the convenience functions. You can use the in one of the following modes: Sportrex Trailer mode: Carrying children in the when cycling... -
Page 12: Insert Tow Bar
Utilisation Utilisation Setting the wheel so that it turns freely (Buggy mode) Filling the pouch for small items It must be possible for the wheel to move freely through 360° in order to manoeuvre in Buggy Put those utensils into the pouch for small items which you want to have readily to hand while mode. -
Page 13: Embarking The Children
Before every journey, check that the safety harnesses and harness catches are sitting Make sure that the loaded weighs less than 40 kg. Sportrex1 correctly. Failure of the restraining function can result in serious or even fatal injuries Make sure that the loaded weighs less than 60 kg. -
Page 14: Connecting The Trailer To A Bicycle
Utilisation Utilisation Connecting the trailer to a bicycle Opening the weather canopy: Roll up the rain window and secure the roll at the top Danger! with the two toggle fasteners. Do not connect the to a bicycle until the following conditions have been Closing the weather canopy: Sportrex fulfilled:... -
Page 15: Adjusting The Tilt Of The Backrest
Utilisation Utilisation Storage Adjusting the tilt of the backrest For the backrest you can set two tilt angles by moving its upper horizontal bar: To store the , simply fold it up and keep it in a protected location. Pay attention also to Sportrex the instructions in the chapter “Care”... -
Page 16: Care And Maintenance
At higher storage temperatures, you should store the wheels separately from the cabin ƒ because the tyres’ rubber can cause odours. Every three years (or every 3000 km) Use a Qeridoo folding garage if the must be kept outdoors, see “Accessories” on ƒ... -
Page 17: Appendix
Length (with tow bar) 144 cm 144 cm Under no circumstances shall Qeridoo be liable for material damage or injury attributable to Width (external width from wheel to wheel) 75 cm 85 cm improper assembly, the intentional alteration of components or the non-observance of warning... -
Page 18: Spare Parts
Cover incl. harness system Push-in axle / hub axle (blue, violet, green, red, Art. no.: ZT6-2016 anthracite) Art. no.: BEZUG-30-17 (Sportrex1) Art. no.: BEZUG-600-17 (Sportrex2) Plastic cylinder for mounting Cover, top part the wheel and parking brake (blue, violet, green, red, anthracite) Art. - Page 19 Sportrex Qeridoo GmbH Reutherstraße 3, 53773 Hennef (Sieg) Germany www.qeridoo.de info@qeridoo.de...