Page 2
When the product is sealed it is water resistant to IP56. Box Contents. 1 x GENESIS LGKSQ Key Point 1 x Relay module Copyright 2016 Luminite Electronics Ltd All rights reserved. Unauthorised duplication of this handbook by any means mechanical or electrical, is strictly prohibited without the express written permission of Luminite Electronics Ltd.
Page 3
INDEX page Introduction. Examples Masthead transceiver. Fitting the relay module. Preparing the Key Point for use. Learn mode. Example LGKSQ Wireless Key Point Installation Handbook Page 10. LGKSQ Wireless Key Point Installation Handbook Page 3.
Page 4
CCTV industry to simplify the requirement to Set and Un-Set a system from the Keep holding * and type 3,2,5,6,9,8. perimeter of the site. A Genesis IP Masthead must be used in conjunction with the keypoint with a firmware version of Z54 or higher. Let go of the star button and all three Each key point is supplied with a relay module that is plugged on to an IP masthead transceiver but only one module is required.
Page 5
The LED will no longer flash and will either be ON or OFF depending on the status. Fig 1. LED ON is SET and the relay will be closed. LED OFF is Un-SET and the relay will be open. LGKSQ Wireless Key Point Installation Handbook Page 8. LGKP Wireless Key Point Installation Handbook...
Page 6
Masthead transceiver. Preparing the key point for use. In order for the Key Point to work it must be used in conjunction with a Genesis The LGKSQ require a PP3 IP Masthead transceiver with firmware version Z55 or higher. The Masthead is weather 9 volt battery to operate.
Need help?
Do you have a question about the LGKSQ and is the answer not in the manual?
Questions and answers