No spindle motor operation
The below waveform is
outputted in IC102 123PIN?
1. DMSO
Figure
2. U.V.W
Figure
Y
Do Pins 14(W),13(V), 12(U) show
waveforms as the ones shown in Figure 2?
Y
FFC of connector CN601
is normally inserted?
Y
Replace of spindle motor
The Movement of the Spindle
In case of CD - ROM READ
Output the upper and lower on
the basis of 1.65V in
123PIN of IC102.
The Pin No.6 of IC609 has a
square wave output.
Check the power of U10, soldering and
N
replace of IC102.
N
Check the power of IC609, GND, soldering
and replace of IC609.
N
After correct insertion of
FFC to Connector, then retest.
The spindle motor rotates.
IC609 8PIN
continues to show
voltage changes as RPM changes.
(Moves above and below VREF)
15