Summary of Contents for JAKOB HATTELAND JH 20T01 M20
Page 1
20,1” TFT CONT BRIGHT ON JH 20T01 M20 - 20,1 inch Industrial TFT Display For 12-24 VDC and touchscreen versions. Jakob Hatteland Display AS Created : 11 Jul, 2001 Modifi ed : 13 Nov, 2001 Created by: Stein Eikesdal Title...
The display controller and the high light intensity in combination with the high contrast and wide back light adjustment control allow the product to be used in many environments. CONT BRIGHT ON JH 20T01 M20 - 20,1 inch Industrial TFT Display CONTENTS: OPERATION.................. 3 Power switch, Display Adjustment Controls............
USER CONTROLS / OSD MENU Product:JH 20T01 M20 MENU / EXIT ENTER - /UP + / DOWN Power LED Adjust Navigation buttons USER CONTROLS: The On Screen Manager (OSD Menu) controls are located under the metal hatch on the left side of the display.
OSD MENU / SETUP Product:JH 20T01 M20 OSD MENU: Pressing the “MENU” button will bring up the MAIN MENU, press “MENU” again to exit. Use the naviagation buttons to select desired sub-menu, enter the menu by pressing the “ENTER” button.
OSD MENU / PICTURE Product:JH 20T01 M20 PICTURE MENU: (Sub-menu) This sub-menu will enable the user to adjust brightness, contrast, color temperature (degree Kelvin). BRIGHTNESS Adjust the brightness using the “-/UP” and “+/DOWN” buttons. A value of 48 indicates the default setting.
OSD MENU / OPTIONS Product:JH 20T01 M20 OPTIONS MENU: (Sub-menu) This sub-menu will enable the user to confi gure On Screen Manager options like choosing language for all the OSD menus. PROMPT When PROMPT is set to ON, the info mode automatically appears for a short while whenever the video mode is changed.
OSD MENU / MODE INFO & SERVICE Product:JH 20T01 M20 MODE INFO: (Sub-menu) This sub-menu displays the parameters and technical information for the current video mode. Mode: The resolution is given on a number of lines basis. HFreq: H-Sync frequency to within 4khz...
PHYSICAL CONNECTIONS Product: JH 20T01 M20 Rear side of display Signal Input Touchscreen (opt) POWER 9-36VDC CAUTION TO PREVENT ELECTRIC SHOCK DO NOT REMOVE THE ENCLOSURE NO USER SERVICEABLE PARTS INSIDE Power Terminal SIGNAL INPUT: This is normally factory mounted, but if not connect the BNC cable to the fi ve BNC connectors on the rear side of the display.
TROUBLESHOOTING Product:JH 20T01 M20 COMMON ERRORS: If for some reason there should be something wrong with the picture quality or no picture present, check the symptoms carefully and try to cure it with the hints below: NO PICTURE / LED BEHAVIOUR: Power Switch and computer power switch should be in the ON position.
PRESET SIGNAL TIMING Product:JH 20T01 M20 PRESET SIGNAL TIMING TABLE: This TFT display is capable of detecting the following resolutions along with its preset signal timing setting. These settings have been pre-programmed by the VGA controller factory. Preset Resolution Vert. Frequency(KHz) Horiz.