Setup Mode - Xeecom VENTUS W232 Owner's Manual

Press [SLIDESHOW] to enable or disable the slideshow
To set the calendar, enter SETUP mode for setting

SETUP MODE

Press [UP]/[DOWN] to move to your setting item. Press [LEFT]/[RIGHT] to select the setting and press [ENTER]
to confirm the setting.
Language:
Slideshow Time:
Transition Effect:
Photo repeat mode:
Display mode:
On/Off Timer 1 - On:
On/Off Timer 1 - Off:
On/Off Timer 2 - On:
On/Off Timer 2 - Off:
Brightness:
Contrast:
Saturation:
Radio-Controlled Clock:
Radio-Controlled Reception:
Time Offset:
Time:
Calendar Display Format:
Time Format:
Alarm:
Wireless Sensor Reception:
Temperature Unit:
Weather Forecast:
Pressure Unit:
Remote Channel Display:
Select between English, Dutch & French
Select between 3s, 5s, 15s, 1 min, 15 min & 1 hour for photo slideshow mode
Select the transition effect of the photo slideshow mode
Select between random, manual or repeat all for the photo slideshow mode
Select the photo display mode (cinema, stretch, crop)
Adjust the first automatic power on time in HH:MM; enable or disable
Adjust the first automatic power off time in HH:MM; enable or disable
Adjust the second automatic power on time in HH:MM; enable or disable
Adjust the second automatic power off time in HH:MM; enable or disable
(For power saving, you can select when to turn on or off the photo frame
automatically throughout the day using the On/Off timer 1 or 2)
Select the brightness of the display from level 1 to 16
Select the contrast of the display from level 1 to 16
Select the saturation of the display from level 1 to 16
Enable or disable the radio-controlled clock (Default: enable)
Automatic - search for radio-controlled daily at around 2:03am
Search now - start searching for radio-controlled clock signal
Off – turn off the daily radio-controlled clock reception
Adjust the clock to your local time using the time offset setting
Adjust the calendar and time
(You need to do this if your photo frame cannot receive radio-controlled clock
signal)
Select between Day/Month or Month/Day format
Select between 24 & 12 hour format
Adjust the alarm time and enable/disable the alarm
Automatic – default RF reception mode
Search now – Search for remote sensor immediately
Select between degree C & F for temperature, heat index & dew point
Select between sunny, partly cloudy, cloudy, rainy & stormy
Select pressure unit between hPa, mmHg, inHg & mb
Automatic – Show the channel(s) being registered
Channel 1 only – Shows only channel 1 reading only
16