Advertisement
Step 8 - Remove the 15mm bolts from the roll cage on both right and left front roll cage junctions.
Take the RZRPOD65 and the bracket and align the bracket mounting holes to the roll cage junction.
The 15mm bolts that were removed will hold the bracket tight to the roll cage. The enclosures will sit
within the front corners of the dash.
Step 9 - Securely attach the brackets to the enclosure using the provided M4 Screws. Using
isopropyl alcohol, wipe any areas of the dash surface that will make contact with the speaker
enclosures. Remove the tape backing. Align the bracket holes with the holes in the roll cage and
press the enclosure into place. Replace the 15mm bolts in the roll cage, making sure to place the
provided M4 washers between the mounting bracket and roll cage. Tighten the 15mm bolts into the
roll cage per the manufacturer specified torque (Torque spec 40 ft-lbs.).
6
M T X . C O M
Advertisement
