Keebox W150NR Quick Installation Manual page 10

Troubleshooting
1. I typed http://192.168.10.1 in my Internet Browser's Address Bar, but an error message says
"The page cannot be displayed." How can I get into the W150NR's web configuration page?
1. Check your hardware settings again by following the instructions in Section 2.
2. Make sure the LAN and WLAN lights are lit.
3. Make sure your TCP/IP settings are set to Obtain an IP address automatically (see the steps
below).
4. Press on the factory reset button for 15 seconds.
Windows 7
1. Go into the Control Panel, click Network and
Sharing Center, click Change Adapter
Settings and then right-click the Local Area
Connection icon and then click Properties.
2. Click Internet Protocol Version 4 (TCP/IPv4)
and then click Properties. Then click on Obtain
an IP address automatically.
Windows Vista
1. Go into the Control Panel, click Network and
Internet, click Network and Sharing Center,
click Manage Network Connections and then
right-click the Local Area Connection icon and
then click Properties.
2. Click Internet Protocol Version 4(TCP/IPv4)
and then click Properties. Then click on Obtain
an IP address automatically.
8