Battery Saver; Automatic Power Off - Kenwood TH-27A Instruction Manual

4-11. BATTERY SAVER
The transceiver provides a battery saver mode to con-
serve on battery power. The transceiver will activate the
battery saver circu it 10 seconds after the last key
operation with the squelch closed. The function will be
released by key operation or when squelch opens.
The function cannot operate during scan. or T.AL T
operations.
1. Press the F key for longer than 1 second and then press
the LOW key. S indicator will light (Initial state is ON.)
( F )
more than 1
second
CLOCK
LOW
<0
,uu
nn
, , I.UU
I!l1m IUfO
2. The function will be released by any key operation or
when squelch opens.
3. The function can be turned off by pressing the F key
for longer than 1 second and LOW key again .
42
4 -12. A UTOMATIC POWER OFF
This transceiver also provides an Automatic Power OFF
circu it. The circuit action is described below. (Initial state
is ON .)
1. A 5 second audio confirmation alert w ill sound after
59
minutes if no signal has been received and if you
have not performed any operation .
1 minute after this alert signal the transceiver will turn
the power switch off.
2. To turn the APO function OFF/ON. press the F key for
longer than 1 second and then press the O/ L.OUT key.
( F )
more than 1
second
L. OUT
( 0 )
NOTE
~
1!l1m _
l
"l,u nn
J
' 1.UU
IiIAPO
APO function does not activate during scan or the
TONE AL ERT function in spite of lighting the APO in-
dicator.