Exit C Parameter Setting; Parameter Copy - Suzhou Kunteng Electronics Co KT-LCD5 User Manual

C14 parameter definition table:
C14 Value
After finishing C14 parameter setting, hold
set values and enter C1 parameter setting interface again. Or hold
for about 2 seconds to exit C parameter setting environment and return to the display 1.
○

Exit C Parameter Setting

Among the fourteen C parameter settings, when each parameter setting is completed,
if held button (SW) long for about 2 seconds, all can exit the setting environment
and return to display 1, meanwhile, the current set parameters would be saved.
Under each parameter setting interface, if there's no button operation on the meter for
more than 1 minute, and then the meter will automatically return to display 1, and the
original set parameters will be saved.

Parameter Copy

Set parameters (include general project parameter, P parameter and C parameter) of
all KT-LCD5 meter produced by our company according to requirements, and set the meter
to be a data source according to the method of "C11 Attribute Selection Setting".
Use special wiring cables to properly wire to LCD5 meter needs to be copied
according to the diagram.
ELECTRIC BICYCLE METER KT—LCD5 Product User Manual
1
2
3
Meter parameter copy wiring diagram
Assist strength of intelligent pedal motor
Weak assist strength of motor
General assist strength of motor
Stronger assist strength of motor
button (SW) shortly to save current
- 35 -
button (SW) long