The Eaganmatrix Expander And Combination Presets; Using Both An Eaganmatrix Expander And The Continuum Voltage Converter - Haken Audio EaganMatrix User Manual

H a k e n A u d i o - E a g a n M a t r i x E x p a n d e r U s e r ' s G u i d e

3.2. The EaganMatrix Expander and Combination Presets

Both the xCEE and the iCEE allow for the ability to combine three EaganMatrix Presets. These Presets can be
performed under the same finger control, split into different regions of the playing surface, connected in a serial
fashion, are cued for instantaneous overlapping patch switching. Refer to the Continuum User Guide for further
information.
Combination Preset DSP 1 in italics DSP 2 and 3 immediately after DSP 1
4.

Using both an EaganMatrix Expander and the Continuum Voltage Converter.

If you have a Continuum Voltage Converter (CVC) you must Connect your CVC to Data Port 4 on the Expander.
The CVC will not work if you connect it directly to your Continuum Fingerboard when the EaganMatrix
Expander is present.
to 1st CVC "In"
to 2nd CVC "In"
If you have two CVCs, connect the second CVC to the xCEE's Data 2 connector.
You must power on a CVC whenever it is connected; the LEDs flash violet if a CVC is connected without power.
P a g e 6